Related papers: mTOF performance during mCBM beam time at GSI
A new kind of Multi-gap Resistive Plate Chamber (MRPC) has been built for the large-area Muon Telescope Detector (MTD) for the STAR experiment at RHIC. These long read-out strip MRPCs (LMRPCs) have an active area of 87.0 x 17.0 cm2 and ten…
A large Time Projection Chamber (TPC) is the main device for tracking and charged-particle identification in the ALICE experiment at the CERN LHC. After the second long shutdown in 2019-2020, the LHC will deliver Pb beams colliding at an…
MicroBooNE is a neutrino experiment located in the Booster Neutrino Beamline (BNB) at Fermilab, which collected data from 2015 to 2021. MicroBooNE's liquid argon time projection chamber (LArTPC) is accompanied by a photon detection system…
The energy range from a few hundred keV to a few MeV includes important probes such as nuclear gamma-rays and the 511 keV annihilation line. However, compared to X-rays and GeV/TeV gamma-rays, this range suffers from lower sensitivity by…
The BASE collaboration aims to measure antimatter systems with the highest precision in order to perform a rigorous test of CPT symmetry and search for physics beyond the Standard Model. As part of the BASE collaboration, we pursue the…
A new design for heavy-ion beam driven isentropic compression experiments is suggested and analysed. The proposed setup utilises long stopping ranges and the variable focal spot geometry of the high-energy uranium beams delivered at the GSI…
A new type of resistive plate chamber with thin-film electrodes based on diamond-like carbon is under development for background identification in the MEG II experiment. Installed in a low-momentum and high-intensity muon beam, the detector…
The Anti-Proton ANnihilation at DArmstadt (PANDA) experiment proposed at the Facility for Antiproton and Ion Research (FAIR) in Darmstadt (Germany) will perform a high precision spectroscopy of charmonium and exotic hadrons, such as…
CBM (Compressed Baryonic Matter) is mainly used to study QCD phase diagram of strong interactions in high and moderate temperature region. Before the next generation GBTx based CBM DAQ system is built up, the DPB (Data Processing Board)…
With the development of the circular collider, it is necessary to make accurate physics experimental measurements of particle properties at higher luminosity $Z$ pole. Micro-pattern gaseous detectors (MPGDs), which contain Gaseous Electron…
Time-of-flight (ToF) measurements is a possible alternative to anti-scatter grids in computed tomography (CT). Simulations have shown a possible 75% reduction in the detrimental scattering contribution with a 100 ps FWHM timing resolution.…
Recent experimental results obtained in STAR experiment at the Relativistic heavy-ion collider (RHIC) with ion beams will be discussed. Investigations of different nuclear collisions in some recent years focus on two main tasks, namely,…
In this paper we present the R&D activity on a new GEM-based TPC prototype for AMADEUS, a new experimental proposal at the DA{\Phi}NE {\Phi}-factory at the Laboratori Nazionali di Frascati (INFN), aiming to perform measurements of the…
An electrostatic time-of-flight detector named E-MCP has been developed for quick diagnostics of circulating beam and timing measurement in mass spectrometry at the Rare-RI Ring in RIKEN. The E-MCP detector consists of a conversion foil,…
The TORCH time-of-flight detector is designed to provide a 15 ps timing resolution for charged particles, resulting in $\pi$/$K$ particle identification up to 10 GeV/c momentum over a 10 m flight path. Cherenkov photons, produced in a…
In this paper we report on the current status of studies on the expected performance for a detector designed to operate in a muon collider environment. Beam-induced backgrounds (BIB) represent the main challenge in the design of the…
Accurate Time-of-Flight (TOF) measurement with sub-100 picosecond resolution is a critical requirement for particle identification in future high-energy physics experiments, such as the Belle II $K_{L}$ and Muon (KLM) detector upgrade.…
A new prototype of large area Multi-gap Resistive Plate Chamber (MRPC) with long readout strips was built. This Long-strip Multi-gap Resistive Plate Chamber (LMRPC) is double stacked and has ten 250 $\mu$m-thick gas gaps. Signals are read…
We constructed a new time-of-flight (TOF) detector consisting of resistive plate chambers (RPCs) to measure particle energy in the BGOegg experiment. The BGOegg-RPC has a unique feature which enables us to cover a large area with a small…
The Gamma-Ray and AntiMatter Survey (GRAMS) is a next-generation experiment using a Liquid Argon Time Projection Chamber (LArTPC) detector to measure MeV gamma rays and antiparticles. MeV gamma-ray observations are important for…