Related papers: Capillary control of collapse in soft composite co…
We propose a simple phenomenological model for describing the conformational dynamics of biopolymers via the nonlinearity-induced buckling and collapse (i.e. coiling up) instabilities. Taking into account the coupling between the internal…
Brittle materials fail catastrophically. In consequence of their limited flaw-tolerance, failure occurs by localized fracture and is typically a dynamic process. Recently, experiments on epithelial cell monolayers have revealed that this…
Soft-granular media, such as dense emulsions, foams or tissues, exhibit either fluid- or solid-like properties depending on the applied external stresses. Whereas bulk rheology of such materials has been thoroughly investigated, the…
The capillary forces exerted by liquid drops and bubbles on a soft solid are directly measured using molecular dynamics simulations. The force on the solid by the liquid near the contact line is not oriented along the liquid vapor interface…
We investigate the equilibrium configurations of closed planar elastic curves of fixed length, whose stiffness, also known as the bending rigidity, depends on an additional density variable. The underlying variational model relies on the…
The Tayler instability is a kink-type flow instability which occurs when the electrical current through a conducting fluid exceeds a certain critical value. Originally studied in the astrophysical context, the instability was recently shown…
Filopodia are long, finger-like membrane tubes supported by cytoskeletal filaments. Their shape is determined by the stiffness of the actin filament bundles found inside them and by the interplay between the surface tension and bending…
Non-conservative loads of the follower type are usually believed to be the source of dynamic instabilities such as flutter and divergence. It is shown that these instabilities (including Hopf bifurcation, flutter, divergence, and…
We investigate the finite bending and the associated bending instability of an incompressible dielectric slab subject to a combination of applied voltage and axial compression, using nonlinear electro-elasticity theory and its incremental…
Gels are used to design bilayered structures with high residual stresses. The swelling of a thin layer on a compliant substrate leads to compressive stresses. The post-buckling of this layer is investigated experimentally; the wavelengths…
Euler springs are used for vertical suspension and vibration isolation as they provide a large static supporting force with a low spring-rate and use minimal spring material. To date, multiple single-width rectangular blades of uniform…
Simulation results are presented on the collapse of granular columns composed of rod-like particles. Columns can be stable and free-standing if either the friction coefficient is large enough, or the rods long enough. Destabilizing…
The mechanical properties of biological materials are spatially heterogeneous. Typical tissues are made up of a spanning fibrous extracellular matrix in which various inclusions, such as living cells, are embedded. While the influence of…
In the present work, the overall nonlinear elastic behavior of a 1D multi-modular structure incorporating possible imperfections at the discrete (micro-scale) level, is derived with respect to both tensile and compressive applied loads. The…
We present experiments on the dynamic buckling and fragmentation of slender rods axially impacted by a projectile. By combining the results of Saint-Venant and elastic beam theory, we derive a preferred wavelength lambda for the buckling…
While much work has been done recently in the realm of model-based control of soft robots and soft-rigid hybrids, most works examine robots that have an inherently serial structure. While these systems have been prevalent in the literature,…
This work provides a ground for a quantitative interpretation of experiments on step bunching during sublimation of crystals with a pronounced Ehrlich-Schwoebel (ES) barrier in the regime of weak desorption. A strong step bunching…
We present a simple method for accessing the elastic properties of microscopic deformable particles. This method is based on measuring the pressure-induced deformation of soft particles as they are forced through a tapered glass…
We study the interaction between capillary forces and deformation in the context of a deformable capillary adhesive: a clamped, tense membrane is adhered to a rigid substrate by the surface tension of a liquid droplet. We find that the…
We study the interaction of small hydrophobic particles on the surface of an ultra-soft elastic gel, in which a small amount of elasticity of the medium balances the weights of the particles. The excess energy of the surface of the deformed…