Related papers: Site-specific online compressive beam codebook lea…
To overcome the high path-loss and the intense shadowing in millimeter-wave (mmWave) communications, effective beamforming schemes are required which incorporate narrow beams with high beamforming gains. The mmWave channel consists of a few…
This paper introduces a novel channel knowledge map (CKM)-assisted dual-domain tracking and predictive beamforming scheme for high-mobility wireless networks. The central premise is that the CKM integrates both the coordinate and beam…
Directional transmission patterns (a.k.a. narrow beams) are the key to wireless communications in millimeter wave (mmWave) frequency bands which suffer from high path loss and severe shadowing. In addition, the propagation channel in mmWave…
Channel knowledge map (CKM), which aims to directly reflect the intrinsic channel properties of the local wireless environment, is a novel technique for achieving environmentaware communication. In this paper, to alleviate the large…
Millimeter-wave (mm-wave) communications incur a high beam alignment cost in mobile scenarios such as vehicular networks. Therefore, an efficient beam alignment mechanism is required to mitigate the resulting overhead. In this paper, a…
Massive MIMO is a promising technique for future 5G communications due to its high spectrum and energy efficiency. To realize its potential performance gain, accurate channel estimation is essential. However, due to massive number of…
Traffic Matrix estimation has always caught attention from researchers for better network management and future planning. With the advent of high traffic loads due to Cloud Computing platforms and Software Defined Networking based tunable…
Huge overhead of beam training imposes a significant challenge in millimeter-wave (mmWave) wireless communications. To address this issue, in this paper, we propose a wide beam based training approach to calibrate the narrow beam direction…
Millimeter-wave (mmWave) and terahertz (THz) communications require beamforming to acquire adequate receive signal-to-noise ratio (SNR). To find the optimal beam, current beam management solutions perform beam training over a large number…
Accurate parameter estimation such as angle of arrival (AOA) is essential to enhance the performance of integrated sensing and communication (ISAC) in mmWave multiple-input multiple-output (MIMO) systems. This work presents a sensing-aided…
In millimeter wave communications, beam training is an effective way to achieve beam alignment. Traditional beam training method allocates training resources equally to each beam in the pre-designed beam training codebook. The performance…
Next generation wireless networks will exploit the large amount of spectrum available at millimeter wave (mmWave) frequencies. Design of mmWave systems, however, is challenging due to strict power, cost and hardware constraints at higher…
Communication systems at millimeter-wave (mmW) and sub-terahertz frequencies are of increasing interest for future high-data rate networks. One critical challenge faced by phased array systems at these high frequencies is the efficiency of…
The mmWave communication system is operating at a regime with high number of antennas and very limited number of RF analog chains. Large number of antennas are used to extend the communication range for recovering the high path loss while…
Fast millimeter wave (mmWave) channel estimation techniques based on compressed sensing (CS) suffer from low signal-to-noise ratio (SNR) in the channel measurements, due to the use of wide beams. To address this problem, we develop an…
Millimeter wave (mmWave) communication is one feasible solution for high data-rate applications like vehicular-to-everything communication and next generation cellular communication. Configuring mmWave links, which can be done through…
Intelligent Transportation Systems (ITSs) require ultra-low end-to-end delays and multi-gigabit-per-second data transmission. Millimetre Waves (mmWaves) communications can fulfil these requirements. However, the increased mobility of…
Mobile users are prone to experience beam failure due to beam drifting in millimeter wave (mmWave) communications. Sensing can help alleviate beam drifting with timely beam changes and low overhead since it does not need user feedback. This…
In orthogonal frequency division modulation (OFDM) communication systems, channel state information (CSI) is required at receiver due to the fact that frequency-selective fading channel leads to disgusting inter-symbol interference (ISI)…
Channel estimation at millimeter wave (mmWave) is challenging when large antenna arrays are used. Prior work has leveraged the sparse nature of mmWave channels via compressed sensing based algorithms for channel estimation. Most of these…