Related papers: Bit-Interleaved Coded Multiple Beamforming with Pe…
We examine the capacity of beamforming over a single-user, multi-antenna link taking into account the overhead due to channel estimation and limited feedback of channel state information. Multi-input single-output (MISO) and multi-input…
This paper studies the transmit waveform optimization for a quantized multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system, where one-bit analog-to-digital converters (ADCs) are employed to enable a…
At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…
Training sequences are designed to probe wireless channels in order to obtain channel state information for block-fading channels. Optimal training sounds the channel using orthogonal beamforming vectors to find an estimate that optimizes…
Massive multiple-input multiple-output (MIMO) systems are cellular networks where the base stations (BSs) are equipped with unconventionally many antennas. Such large antenna arrays offer huge spatial degrees-of-freedom for transmission…
Massive multi-input multi-output (MIMO) uses a very large number of low-power transmit antennas to serve much smaller numbers of users. The most widely proposed type of massive MIMO transmit beamforming is zero-forcing, which is based on…
This paper presents Bit-Interleaved Coded Modulation metrics for joint estimation detection using training or reference signal transmission strategies for short to long block length channels. We show that it is possible to enhance the…
Spatial multiplexing (SMX) multiple-input multiple-output (MIMO) over the best beamspace was considered as the best solution for millimeter wave (mmWave) communications regarding spectral efficiency (SE), referred as the best beamspace…
This paper investigates a new analog beamforming architecture for massive multiple-input multiple-output (MIMO) systems, where each of the multiple transmit antennas is switched to be on or off to form a beam according to the channel state…
In order to meet the demands of `Internet above the clouds', we propose a multiple-antenna aided adaptive coding and modulation (ACM) for aeronautical communications. The proposed ACM scheme switches its coding and modulation mode according…
We address the problem of designing a transmit beampattern for multiple-input multiple-output (MIMO) radar considering co-existence with wireless communication systems. The designed beampattern is able to manage the transmit energy in…
In cell-free massive multiple-input multiple-output (MIMO) the fluctuations of the channel gain from the access points to a user are large due to the distributed topology of the system. Because of these fluctuations, data decoding schemes…
In this paper, we consider {\em media-based modulation (MBM)}, an attractive modulation scheme which is getting increased research attention recently, for the uplink of a massive MIMO system. Each user is equipped with one transmit antenna…
This paper studies the beamforming design problem to achieve max-min fairness (MMF) in multibeam satellite communications. Contrary to the conventional linear precoding (NoRS) that relies on fully treating any residual interference as…
Reconfigurable antenna multiple-input multiple-output (MIMO) is a promising technology for upcoming 6G communication systems. In this paper, we deal with the problem of configuration selection for reconfigurable antenna MIMO by leveraging…
There have been recent works on enabling in-band full-duplex operation using millimeter-wave (mmWave) transceivers. These works are based solely on creating sufficient isolation between a transceiver's transmitter and receiver via…
This paper explores the energy efficiency (EE) of integrated sensing and communication (ISAC) systems employing massive multiple-input multiple-output (mMIMO) techniques to leverage spatial beamforming gains for both communication and…
Achieving high bit rates is the main goal of wireless technologies like 5G and beyond. This translates to obtaining high spectral efficiencies using large number of antennas at the transmitter and receiver (single user massive multiple…
In millimeter-wave communications, multiple-input-multiple-output (MIMO) systems use large antenna arrays to achieve high gain and spectral efficiency. These massive MIMO systems employ hybrid beamformers to reduce power consumption…
We revisit the information-theoretic analysis of bit-interleaved coded modulation (BICM) by modeling the BICM decoder as a mismatched decoder. The mismatched decoding model is well-defined for finite, yet arbitrary, block lengths, and…