Related papers: Beamspace Precoding and Beam Selection for Wideban…
This paper addresses joint transceiver and relay design for a wireless multiple-input-multiple-output (MIMO) switching scheme that enables data exchange among multiple users. Here, a multi-antenna relay linearly precodes the received…
In this paper, we propose an energy-efficient radar beampattern design framework for a Millimeter Wave (mmWave) massive multi-input multi-output (mMIMO) system, equipped with a hybrid analog-digital (HAD) beamforming structure. Aiming to…
Massive MIMO systems promise high data rates by employing large number of antennas, which also increases the power usage of the system as a consequence. This creates an optimization problem which specifies how many antennas the system…
In this paper, we investigate the problem of beam alignment in millimeter wave (mmWave) systems, and design an optimal algorithm to reduce the overhead. Specifically, due to directional communications, the transmitter and receiver beams…
Massive MIMO is a variant of multiuser MIMO where the number of base-station antennas $M$ is very large (typically 100), and generally much larger than the number of spatially multiplexed data streams (typically 10). Unfortunately, the…
Millimeter wave (mmWave) communication with large array gains is a key ingredient of next generation (5G) wireless networks. Effective communication in mmWaves usually depends on the knowledge of the channel. We refer to the problem of…
Analog/digital hybrid precoder and combiner have been widely used in millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems due to its energy-efficient and economic superiorities. Infinite resolution of phase shifters (PSs)…
The cost of radio frequency (RF) chains is the biggest drawback of massive MIMO millimeter wave networks. By employing spatial modulation (SM), it is possible to implement lower number of RF chains than transmit antennas but still achieve…
This letter presents a low-complexity hybrid precoding framework for multiuser multiple-input multiple-output (MIMO) systems by leveraging a low-dimensional subspace property. Under the low-dimensional subspace perspective, we first…
The focus of this paper is on beamforming in a millimeter-wave (mmW) multi-input multi-output (MIMO) setup that has gained increasing traction in meeting the high data-rate requirements of next-generation wireless systems. For a given MIMO…
Millimeter-wave massive multiple-input multiple-output (MIMO) can use a lens antenna array to considerably reduce the number of radio frequency (RF) chains, but channel estimation is challenging due to the number of RF chains is much…
Communication systems at millimeter-wave (mmW) and sub-terahertz frequencies are of increasing interest for future high-data rate networks. One critical challenge faced by phased array systems at these high frequencies is the efficiency of…
A major source of difficulty when operating with large arrays at mmWave frequencies is to estimate the wideband channel, since the use of hybrid architectures acts as a compression stage for the received signal. Moreover, the channel has to…
MIMO technology has enabled spatial multiple access and has provided a higher system spectral efficiency (SE). However, this technology has some drawbacks, such as the high number of RF chains that increases complexity in the system. One of…
This work proposes a novel joint design for multiuser multiple-input multiple-output wiretap channels. The base station exploits a switching network to connect a subset of its antennas to the available radio frequency chains. The switching…
Multi-beam selection is one of the crucial technologies in hybrid beamforming systems for frequency-selective fading channels. Addressing the problem in the frequency domain facilitates the procedure of acquiring observations for analog…
In this paper, adaptive training beam sequence design for efficient channel estimation in large millimeter-wave(mmWave) multiple-input multiple-output (MIMO) channels is considered. By exploiting the sparsity in large mmWave MIMO channels…
Base station (BS) architectures for massive multi-user (MU) multiple-input multiple-output (MIMO) wireless systems are equipped with hundreds of antennas to serve tens of users on the same time-frequency channel. The immense number of BS…
Millimeter-wave is one of the technologies powering the new generation of wireless communication systems. To compensate the high path-loss, millimeter-wave devices need to use highly directional antennas. Consequently, beam misalignment…
In this paper, the precoding design is investigated for maximizing the throughput of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems with obstructed direct communication paths. In particular, a reconfigurable…