Related papers: Evaluation and mitigation of trace $^{210}$Pb cont…
A new experimental equipment allowing to study the sputtering induced by ion beam irradiation is presented. The sputtered particles are collected on a catcher which is analyzed in situ by Auger electron spectroscopy without breaking the…
We propose a design for a plasmonic copper metamaterial with a negative index of refraction at visible/near-infrared wavelengths. Using numerical simulations, we demonstrate negative refraction by a copper metamaterial prism, and perform a…
Noble liquid radiation detectors have long been afflicted by spurious electron emission from their cathodic electrodes. This phenomenon must be understood and mitigated in the next generation of liquid xenon (LXe) experiments searching for…
X-ray and gamma-ray polarimetry is a promising tool to study the geometry and the magnetic configuration of various celestial objects, such as binary black holes or gamma-ray bursts (GRBs). However, statistically significant polarizations…
To understand the complex interplay of topography and surface chemistry in wetting, fundamental studies investigating both parameters are needed. Due to the sensitivity of wetting to miniscule changes in one of the parameters it is…
Silicon photomultipliers (SiPM) are the photon detectors chosen for the tracking readout in NEXT, a neutrinoless {\beta}{\beta} decay experiment which uses a high pressure gaseous xenon time projection chamber (TPC). The reconstruction of…
The electrical resistivity of conventional metals, such as copper, is known to increase in thin films due to electron-surface scattering, limiting the performance of metals in nanoscale electronics. Here, we find an unusual reduction of…
Sodium iodide crystals doped with thallium NaI(Tl) can be used as detector material for direct dark matter detection by taking advantage of their particle detection properties of scintillation. In order to achieve this, it is crucial that…
In this study, the impurity concentration and magnetic response of nine highly oriented pyrolytic graphite (HOPG) samples with different grades and from different providers were determined using ion beam microscopy and SQUID magnetometry.…
Since its discovery, the environmental instability of exfoliated black phosphorus (2D bP) has emerged as a challenge that hampers its wide application in chemistry, physics, and materials science. Many studies have been carried out to…
Single gap (gas gap 2 mm) bakelite Resistive Plate Chamber (RPC) modules of various sizes from 10 cm \times 10 cm to 1 m \times 1 m have been fabricated, characterized and optimized for efficiency and time resolution. Thin layers of…
Polarized Galactic foregrounds are one of the primary sources of systematic error in measurements of the B-mode polarization of the Cosmic Microwave Background (CMB). Experiments are becoming increasingly sensitive to complexities in the…
Label free tracking of small bio-particles such as proteins or viruses is of great utility in the study of biological processes, however such experiments are frequently hindered by weak signal strengths and a susceptibility to scattering…
Black phosphorous (BP) is one of the most interesting layered materials, bearing promising potential for emerging electronic and optoelectronic device technologies. The crystalline structure of BP displays in-plane anisotropy in addition to…
A new method of cooling positronium down is proposed to realize Bose-Einstein condensation of positronium. We perform detail studies about three processes (1) thermalization processes between positronium and silica walls of a cavity, (2)…
We have examined the impact of charged impurity scattering on charge carrier transport in bilayer graphene (BLG) by deposition of potassium in ultra-high vacuum at low temperature. Charged impurity scattering gives a conductivity which is…
Additive microfabrication processes based on localized electroplating enable the one-step deposition of micro-scale metal structures with outstanding performance, e.g. high electrical conductivity and mechanical strength. They are therefore…
We present a method for density-functional modeling of metallic overlayers grown on metallic supports. It offers a tool to study nanostructures and combines the power of self-consistent pseudopotential calculations with the simplicity of a…
We present an analysis of the main systematic effects that could impact the measurement of CMB polarization with the proposed CORE space mission. We employ timeline-to-map simulations to verify that the CORE instrumental set-up and scanning…
We present measurements of hard x-rays in the 50-300 keV range from copper plasmas produced by 100 fs, 806 nm laser pulses at a peak intensity ~ 1016 W cm-2. Surface roughness, even at the tens of nanometer level, is shown to influence the…