Related papers: Robust Joint Source-Relay-Destination Design Under…

Robust transceiver design against unresolvable system uncertainties is of crucial importance for reliable communication. For instance, full-duplex communication suffers from such uncertainties when canceling the self-interference, since…

In this paper, a hybrid IRS-aided amplify-and-forward (AF) relay wireless network is put forward, where the hybrid IRS is made up of passive and active elements. For maximum signal-to-noise ratio (SNR), a low-complexity method based on…

In this paper, we investigate the downlink secure beamforming (BF) design problem of cloud radio access networks (C-RANs) relying on multicast fronthaul, where millimeter-wave and microwave carriers are used for the access links and…

We consider a network of agents that locate themselves in an environment through sensor measurements and aim to transmit a message signal to a base station via collaborative beamforming. The agents' sensor measurements result in…

In this paper, a general cognitive radio system consisting of a set of users with different level of spectrum access including two primary transceivers and several types of secondary users is considered. It is assumed that two secondary…

This paper considers a multipair amplify-and-forward massive MIMO relaying system with low-resolution ADCs at both the relay and destinations. The channel state information (CSI) at the relay is obtained via pilot training, which is then…

Transmit optimization and resource allocation for wireless cooperative networks with channel state information (CSI) uncertainty are important but challenging problems in terms of both the uncertainty modeling and performance op-…

A simple method is proposed for use in a scenario involving a single-antenna source node communicating with a destination node that is equipped with two antennas via multiple single-antenna relay nodes, where each relay is subject to an…

Multi-cell cooperation is an effective means to improve service quality to cellular users. Existing work primarily focuses on interference cancellation using all the degrees of freedom (DoF). This leads to low service quality for some users…

This paper is on beamforming in wireless relay networks with perfect channel information at relays, the receiver, and the transmitter if there is a direct link between the transmitter and receiver. It is assumed that every node in the…

We derive optimal SNR-based transmit antenna selection rules at the source and relay for the nonregenerative half duplex MIMO relay channel. While antenna selection is a suboptimal form of beamforming, it has the advantage that the…

This paper studies simultaneous wireless information and power transfer (SWIPT) systems in two-way relaying (TWR) channels. Here, two source nodes receive information and energy simultaneously via power splitting (PS) from the signals sent…

In this paper, we consider a full-duplex (FD) amplify-and-forward (AF) relay system and optimize its power allocation and relay location to minimize the system symbol error rate (SER). We first derive the asymptotic expressions of the…

Selection combining (SC) at the destination for differential amplify-and-forward (AF) relaying is attractive as it does not require channel state information as compared to the semi maximum-ratio-combining (semi-MRC) while delivering close…

This letter considers an unmanned aerial vehicle (UAV)-enabled relay communication system for delivering latency-critical messages with ultra-high reliability, where the relay is operating under amplifier-and-forward (AF) mode. We aim to…

This letter studies joint transmit beamforming and antenna selection at a secondary base station (BS) with multiple primary users (PUs) in an underlay cognitive radio multiple-input single-output broadcast channel. The objective is to…

In this paper, a full-duplex unmanned aerial vehicle (FD-UAV) relay is employed to increase the communication capacity of millimeter-wave (mmWave) networks. Large antenna arrays are equipped at the source node (SN), destination node (DN),…

Beamforming design has been widely investigated for integrated sensing and communication (ISAC) systems with full-duplex (FD) sensing and half-duplex (HD) communication. To achieve higher spectral efficiency, in this paper, we extend…

In this work, we present a novel robust distributed beamforming (RDB) approach to mitigate the effects of channel errors on wireless networks equipped with relays based on the exploitation of the cross-correlation between the received data…

Secure wireless information and power transfer based on directional modulation is conceived for amplify-and-forward (AF) relaying networks. Explicitly, we first formulate a secrecy rate maximization (SRM) problem, which can be decomposed…