Related papers: Multiphase interpolating digital power amplifiers …

The 5th generation (5G) new radio (NR) access technology and the beyond-5G future wireless communication require extremely high data rate and spectrum efficiency. Energy-efficient transmission/reception schemes are also regarded as an…

The Single Carrier-Frequency Division Multiple Access (SC-FDMA) is a transmission technique used in the uplink of Long Term Evolution (LTE) and 5G systems, as it is characterized by reduced transmitted signal envelope fluctuations in…

Collaborative beamforming enables nodes in a wireless network to transmit a common message over long distances in an energy efficient fashion. However, the process of making available the same message to all collaborating nodes introduces…

Spatial signal processors (SSP) for emerging millimeter-wave wireless networks are critically dependent on link discovery. To avoid loss in communication, mobile devices need to locate narrow directional beams with millisecond latency. In…

We present the state of the art of a compact high-energy mid-infrared laser system for TW-level 8-cycle pulses at 7 um. This system consists of an Er:Tm:Ho:fiber MOPA which serves as the seeder for a ZGP-based OPCPA chain in addition to a…

High-energy femtosecond laser pulses in the mid-infrared (MIR) wavelength range are essential for a wide range of applications from strong-field physics to selectively pump and probe low energy excitations in condensed matter and molecular…

The paper introduces a new route towards the ultrafast high laser peak power and energy scaling in a hybrid mid-IR chirped pulse oscillator-amplifier (CPO-CPA) system, without sacrificing neither the pulse duration nor energy. The method is…

In this article, we present a dual-band 28/38-GHz power amplifier (PA) with inter-band suppression for millimeter-wave 5G communications. The dual-band operation is achieved using a center-tapped transformer network with an extra resonator…

Traditional simultaneous wireless information and power transfer (SWIPT) with power splitting assumes perfect channel state information (CSI), which is difficult to obtain especially in the massive multiple-input-multiple-output (MIMO)…

Convergence constrained power allocation (CCPA) in single carrier multiuser (MU) single-input multiple-output (SIMO) systems with turbo equalization is considered in this paper. In order to exploit full benefit of the iterative receiver,…

This paper proposes a novel network framework of intelligent reflecting surface (IRS)-assisted simultaneous wireless information and power transfer (SWIPT) non-orthogonal multiple access (NOMA) networks, where IRS is used to enhance the…

In magnetic resonant coupling (MRC) enabled multiple-input multiple-output (MIMO) wireless power transfer (WPT) systems, multiple transmitters (TXs) each with one single coil are used to enhance the efficiency of simultaneous power transfer…

Initial access in millimeter-wave (mmW) wireless is critical toward successful realization of the fifth-generation (5G) wireless networks and beyond. Limited bandwidth in existing standards and use of phase-shifters in analog/hybrid…

Energy-efficient sense amplifier (SA) circuits are essential for reliable detection of stored memory states in emerging memory systems. In this work, we present four novel sense amplifier (SA) topologies based on phase transition material…

Optimal beamforming designs under imperfect successive interference cancellation (SIC) decoding for a symbiotic network of non-orthogonal multiple access (NOMA) primary users and a secondary ambient tag have been lacking. We address that…

This paper studies the coordinated beamforming design problem for the multiple-input single-output (MISO) interference channel, assuming only channel distribution information (CDI) at the transmitters. Under a given requirement on the rate…

Clock generators are an essential and critical building block of any communication link, whether it be wired or wireless, and they are increasingly critical given the push for lower I/O power and higher bandwidth in Systems-on-Chip (SoCs)…

This paper presents a high linearity PAM-4 transmitter (TX) architecture, consisting of a three-segment micro-ring modulator (MRM) and a matched CMOS driver. This architecture can drive a high-linearity 4-level pulse amplitude (PAM-4)…

In this paper, a technique combing cascaded energy-transfer pumping (CEP) method and master-oscillator power-amplifier (MOPA) configuration is proposed for power scaling of 1.6-um-band single-frequency fiber lasers (SFFLs), where the Er3+…

Multiple-input multiple-output (MIMO) millimeter wave (mmWave) systems are vulnerable to hardware impairments due to operating at high frequencies and employing a large number of radio- frequency (RF) hardware components. In particular,…