Related papers: On CSI-free Multi-Antenna Schemes for Massive RF W…
This paper focuses on wireless energy transfer (WET) to a pair of low complex energy receivers (ER), by only utilizing received signal strength indicator (RSSI) values that are fed back from the ERs to the energy transmitter (ET). Selecting…
RF Wireless Power Transfer (WPT) emerges as a technology for charging autonomous devices, enabling simultaneous power and information transfer. However, with increasing distance, single-input, single-channel rectenna systems are not able to…
Simultaneous wireless information and power transfer (SWIPT) is an effective energy-saving technology, but its efficiency is hindered by environmental factors. The introduction of reconfigurable intelligent surfaces (RIS) has alleviated…
By reconfiguring the propagation environment of electromagnetic waves artificially, reconfigurable intelligent surfaces (RISs) have been regarded as a promising and revolutionary hardware technology to improve the energy and spectrum…
An asymptotic technique is presented for finding the spectral efficiency of multi-antenna links in wireless networks where transmitters have Channel-State-Information (CSI) corresponding to their target receiver. Transmitters are assumed to…
Internet of Things (IoT) devices often come with batteries of limited capacity that are not easily replaceable or rechargeable, and that constrain significantly the sensing, computing, and communication tasks that they can perform. The…
This paper studies the training design problem for multiple-input single-output (MISO) wireless energy transfer (WET) systems in frequency-selective channels, where the frequency-diversity and energy-beamforming gains can be both reaped to…
In this paper, we propose a novel design for the rotary-wing unmanned aerial vehicle (UAV)-enabled full-duplex (FD) wireless-powered Internet of Things (IoT) networks. In this network, the UAV is equipped with an antenna array, and the $K$…
Scavenging energy from ambient radio signals, namely wireless energy harvesting (WEH), has recently drawn significant attention. In this paper, we consider a point-to-point wireless link over the flat-fading channel, where the receiver…
Decades of continuous scaling has reduced the energy of unit computing to virtually zero, while energy-efficient communication has remained the primary bottleneck in achieving fully energy-autonomous IoT nodes. This paper presents and…
Simultaneous wireless information and power transfer (SWIPT) has recently drawn significant interests for its dual use of radio signals to provide wireless data and energy access at the same time. However, a challenging secrecy…
In this paper, we consider a green cloud radio access network (C-RAN) with simultaneous wireless and power transfer ability. In order to reduce the energy consumed for updating the chanel state information (CSI), energy users are divided…
Reconfigurable intelligent surface (RIS)-based communication networks promise to improve channel capacity and energy efficiency. However, the promised capacity gains could be negligible for passive RISs because of the double pathloss…
Enabling technologies for energy sustainable Internet of Things (IoT) are of paramount importance since the proliferation of high data communication demands of low power network devices. In this paper, we consider a Multiple Input Single…
This paper investigates the simultaneous wireless information and power transfer (SWIPT) in cooperative relay networks, where a relay harvests energy from the radio frequency (RF) signals transmitted by a source and then uses the harvested…
This letter considers spectrum sharing between a primary multiuser multiple-input multiple-output (MIMO) wireless energy transfer (WET) system and a coexisting secondary point-to-point MIMO wireless information transmission (WIT) system,…
Radio-frequency (RF) enabled wireless energy transfer (WET), as a promising solution to provide cost-effective and reliable power supplies for energy-constrained wireless networks, has drawn growing interests recently. To overcome the…
Reconfigurable intelligent surfaces (RISs) have recently gained significant interest as an emerging technology for future wireless networks. This paper studies an RIS-assisted propagation environment, where a single-antenna source transmits…
When designing wireless communication systems (WCS), spectral efficiency (SE) has been the main design performance metric. Recently, energy efficiency (EE) is attracting a huge interest due to the massive deployment of power limited WCS…
Channel state information (CSI) has been a key component in traditional wireless communication systems. This might no longer hold in future networks supporting services with stringent quality of service constraints such as extremely…