Related papers: Realization of ppm level pressure stability for pr…
Often it is desirable to stabilize a system around an optimal state. This can be effectively accomplished using feedback control, where the system deviation from the desired state is measured in order to determine the magnitude of the…
We report the impact of hydrostatic pressure on the superconductivity and normal state resistivity of FeTe0.5Se0.5 superconductor. At the ambient pressure the FeTe0.5Se0.5 compound shows the superconducting transition temperature Tconset at…
When the cooling rate $v$ is smaller than a certain material-dependent threshold, the glass transition temperature $T_g$ becomes to a certain degree the "material parameter" being nearly independent on the cooling rate. The common method to…
Based on a recent experimental determination of the static polarizability and a first-principles calculation of the frequency-dependent dipole polarizability of argon, this work presents, by use of a Fabry-P\'erot refractometer operated at…
This study demonstrates the stabilization of a sequential combustor with Nanosecond Repetitively Pulsed Discharges (NRPD). A constant pressure sequential combustor offers key advantages compared to a conventional combustor, in particular, a…
A device to measure viscosity of dielectric oils was developed. The device is an inset to an autoclave system where the temperature and the pressure could be controlled. The device is capable of measuring viscosities up to 400C and 5000psi,…
This work reports superconductivity studies in the intermetallic Ti$_{0.85}$Pd$_{0.15}$ performed in normal conditions and under hydrostatic pressure. The crystal structure of the compound has a body centered cubic at room temperature and…
A number of crystal structures of water have been `superheated' in Monte Carlo simulations. Two well known models for water were considered; namely the TIP4P model and the SPC/E model. By comparing the fluid-solid coexistence temperature to…
The existence of a static lengthscale that grows in accordance with the dramatic slowing down observed at the glass transition is a subject of intense interest. A recent publication compared two proposals for this length scale, one based on…
We investigate pseudogap phenomena in the unitarity limit of a trapped superfluid Fermi gas. Including effect of strong pairing fluctuations within a $T$-matrix approximation, as well as effects of a harmonic trap within the local density…
A new method called `Configurational Temperature' is introduced in the context of dusty plasma, where the temperature of the dust particles, submerged in the plasma, can be measured directly from the positional information of the individual…
We propose a simple experiment to determine whether vortices persist above the superconducting transition temperature Tc in the pseudogap phase of high temperature cuprate superconductors. This involves using a magnetic dot to stabilize a…
Installation of phasor measurement units (PMUs) in a number of substations in the power grid can help assess a set of its values and parameters, in particular those related to the dynamics when disturbances occur in the system. Inertia…
The dependence of the superconducting transition temperature T_{c} on nearly hydrostatic pressure has been determined to 67 GPa in an ac susceptibility measurement for a Li sample embedded in helium pressure medium. With increasing…
Recent advances regarding the interplay between ab initio calculations and metrology are reviewed, with particular emphasis on gas-based techniques used for temperature and pressure measurements. Since roughly 2010, several thermophysical…
Imposing the constraint that the Standard Model effective Higgs potential should have two degenerate minima ( vacua), one of which should be - order of magnitudewise - at the Planck scale, leads to the top mass being 173 +/- 5 GeV and the…
We studied single-crystalline Pr0.5Sr0.5MnO3 by means of measurements of magnetic susceptibility and specific heat at ambient pressure (P), and electrical resistivity (r) in hydrostatic pressures up to 2 GPa. This material displays…
We study the thermodynamical properties of a one-dimensional gas with one-dimensional gravitational interactions, and placed in a uniform mass background. Periodic boundary conditions are implemented as a modification of the potential…
The local heat transfer coefficient measurement with temperature oscillation induced by periodic thermal perturbation - usually via a Gaussian laser beam, was investigated for the impact of the spikiness (i.e., the standard deviation)…
The rate of nuclear muon capture by the proton has been measured using a new experimental technique based on a time projection chamber operating in ultra-clean, deuterium-depleted hydrogen gas at 1 MPa pressure. The capture rate was…