Related papers: Linear State Estimation and Bad Data Detection for…
Traditional largest normalize residual (LNR) test for bad data identification relies on state estimation residuals and thus can only be implemented after running Power System State Estimation (PSSE). LNR may fail to detect bad data in…
This paper proposes a fully distributed robust state-estimation (D-RBSE) method that is applicable to multi-area power systems with nonlinear measurements. We extend the recently introduced bilinear formulation of state estimation problems…
We consider a situation where the state of a system is represented by a real-valued vector. Under normal circumstances, the vector is zero, while an event manifests as non-zero entries in this vector, possibly few. Our interest is in the…
Distribution systems of the future smart grid require enhancements to the reliability of distribution system state estimation (DSSE) in the face of low measurement redundancy, unsynchronized measurements, and dynamic load profiles. Micro…
State estimation and sensor selection problems for nonlinear networks and systems are ubiquitous problems that are important for the control, monitoring, analysis, and prediction of a large number of engineered and physical systems. Sensor…
In this paper we study the question of how to reconstruct the state of a power system using Phasor Measurement Units (PMUs). In our previous research we proved that this question has an affirmative answer imposing some rather strict…
This paper describes recursive algorithms for state estimation of linear dynamical systems when measurements are noisy with unknown bias and/or outliers. For situations with noisy and biased measurements, algorithms are proposed that…
We propose a framework for integrating optimal power flow (OPF) with state estimation (SE) in the loop for distribution networks. Our approach combines a primal-dual gradient-based OPF solver with a SE feedback loop based on a limited set…
This paper introduces an algorithm able to detect and localize the occurrance of a fault in an Active Distribution Network, using the measurements collected by Phasor Measurement Units (PMUs). First, a basic algorithm that works under the…
The impedances of cables and lines used in (multi-conductor) distribution networks are usually unknown or approximated, and may lead to problematic results for any physics-based power system calculation, e.g., (optimal) power flow. Learning…
Power system state estimation (PSSE) is commonly formulated as weighted least-square (WLS) algorithm and solved using iterative methods such as Gauss-Newton methods. However, iterative methods have become more sensitive to system operating…
Modern state and parameter estimations in power systems consist of two stages: the outer problem of minimizing the mismatch between network observation and prediction over the network parameters, and the inner problem of predicting the…
This paper examines the problem of state estimation in power distribution systems under low-observability conditions. The recently proposed constrained matrix completion method which combines the standard matrix completion method and power…
The state estimation of continuous-time nonlinear systems in which a subset of sensor outputs can be maliciously controlled through injecting a potentially unbounded additive signal is considered in this paper. Analogous to our earlier work…
The increasing deployment of distribution-level phasor measurement units (PMUs) calls for dynamic distribution state estimation (DDSE) approaches that tap into high-rate measurements to maintain a comprehensive view of the…
This paper summarizes an optimal state estimation that previously has been used in power systems and discusses the robustness of the by using a system-state controller. Static state estimation (SSE) traditionally tries to linearize power…
This paper considers the problem of simultaneous sensor fault detection, isolation, and networked estimation of linear full-rank dynamical systems. The proposed networked estimation is a variant of single time-scale protocol and is based on…
This paper investigates the state estimation problem for a class of complex networks, in which the dynamics of each node is subject to Gaussian noise, system uncertainties and nonlinearities. Based on a regularized least-squares approach,…
As phasor measurement units (PMUs) become more widely used in transmission power systems, a fast state estimation (SE) algorithm that can take advantage of their high sample rates is needed. To accomplish this, we present a method that uses…
To provide real-time visibility of physics-based states, phasor measurement units (PMUs) are deployed throughout power networks. PMU data enable real-time grid monitoring and control -- and are essential in transitioning to smarter grids.…