Related papers: Polyphase Waveform Design for MIMO Radar Space Tim…
In this paper, we consider waveform design for dualfunction radar-communication systems based on multiple-inputmultiple-out arrays. To achieve better Rician target detection performance, we use the relative entropy associated with the…
A reconfigurable intelligent surface (RIS) is a nearly-passive flat layer made of inexpensive elements that can add a tunable phase shift to the impinging electromagnetic wave and are controlled by a low-power electronic circuit. This paper…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
The focus of this study is on the spectrum sharing between multiple-input multiple-output (MIMO) communications and co-located MIMO radar systems in multi-path environments. The major challenge is to suppress the mutual interference between…
Although routinely utilized in literature, orthogonal waveforms may lose orthogonality in distributed multi-input multi-output (MIMO) radar with spatially separated transmit (TX) and receive (RX) antennas, as the waveforms may experience…
This paper presents a performance comparison of various MIMO radar multiplexing approaches where the increasing number of transmitters adversely affects the dynamic range of the resultant MIMO system. The investigated multiplexing…
This paper aims to design a set of transmitting waveforms in cognitive colocated Multi-Input Multi-Output (MIMO) radar systems considering the simultaneous minimization of spatial- and the range- Integrated Sidelobe Level Ratio (ISLR). The…
Sparse array design aided by emerging fast sensor switching technologies can lower the overall system overhead by reducing the number of expensive transceiver chains. In this paper, we examine the active sparse array design enabling the…
In this paper, we address the problem of transmit beamspace design for multiple-input multiple-output (MIMO) radar with colocated antennas in application to direction-of-arrival (DOA) estimation. A new method for designing the transmit…
This paper focuses on the joint synthesis of constant envelope transmit signal and receive filter aimed at optimizing radar performance in signal-dependent interference and spectrally contested-congested environments. To ensure the desired…
MIMO technology has enabled spatial multiple access and has provided a higher system spectral efficiency (SE). However, this technology has some drawbacks, such as the high number of RF chains that increases complexity in the system. One of…
Reconfigurable intelligent surfaces (RISs) have huge potential to improve spectral and energy efficiency in future wireless systems at a minimal cost. However, early prototype results indicate that deploying hundreds or thousands of…
We consider a radar architecture where an illuminator composed of few sources is used as a feeder for a (passive) reconfigurable intelligent surface (RIS), so as to mimic the behavior of a multiple-input multiple-output (MIMO) radar…
Joint radar receive filter and waveform design is non-convex, but is individually convex for a fixed receiver filter while optimizing the waveform, and vice versa. Such classes of problems are fre- quently encountered in optimization, and…
In millimeter-wave (mmWave) dual-function radar-communication (DFRC) systems, hybrid beamforming (HBF) is recognized as a promising technique utilizing a limited number of radio frequency chains. In this work, in the presence of extended…
The ambiguity function (AF) is a critical tool in radar waveform design, representing the two-dimensional correlation between a transmitted signal and its time-delayed, frequency-shifted version. Obtaining a radar signal to match a…
Spectrum congestion and competition over frequency bandwidth could be alleviated by deploying dual-function radar-communications systems, where the radar platform presents itself as a system of opportunity to secondary communication…
Hybrid beamforming is a promising technology to improve the energy efficiency of massive MIMO systems. In particular, subarray hybrid beamforming can further decrease power consumption by reducing the number of phase-shifters. However,…
Reconfigurable intelligent surface (RIS) refers to a signal reflection surface containing a large number of low-cost passive reflecting elements. RIS can improve the performance of radar and communication systems by dynamically modulating…
Multiple-input multiple-output (MIMO) radars transmit a set of sequences that exhibit small cross-correlation sidelobes, to enhance sensing performance by separating them at the matched filter outputs. The waveforms also require small…