Related papers: Density of Nanometrically Thin Amorphous Films Var…
Drawing inspiration from nature, where some organisms can control the short range order of amorphous minerals, we successfully manipulated the short range order of amorphous alumina by surface and size effects. By utilizing the Atomic Layer…
Inspired by nature, we investigate the short-range order effect on the physical properties of amorphous materials. Amorphous Al2O3 thin films exhibit a higher proportion of their 4-coordinated Al sites close to the surface, causing…
Amorphous silicon films prepared by electron beam evaporation have systematically and substantially greater atomic density for higher thickness, higher growth temperature, and slower deposition rate, reaching the density of crystalline Si…
Plants and insects use slender conical structures to transport and collect small droplets, which are propelled along the conical structures due to capillary action. These droplets can deposit a fluid film during their motion, but despite…
We study the three-dimensional structure formation when atoms are deposited onto a substrate with a decagonal quasicrystalline order. Molecular-dynamicscalculations show that the adsorbate layer consists of ordered nano-scale domains with…
The preferentially (220) orientated polycrystalline silicon films have been fabricated by performing photon-involved rapid thermal annealing upon amorphous silicon films. In contrast, conventional thermal annealing of the silicon amorphous…
Amorphous materials lack long-range order but short-range order can still persist through the recurrence of similar local packing motifs. While the short-range order in bulk amorphous phases has been well studied and identified as an…
We study the effects of time-dependent substrate/film temperature in the deposition of a mesoscopically thick film using a statistical model that accounts for diffusion of adatoms without lateral neighbors whose coefficients depend on an…
Thin films are usually obtained by depositing atoms with a continuous flux. We show that using a chopped flux changes the growth and the morphology of the film. A simple scaling analysis predicts how the island densities change as a…
Carbon is one of the most investigated materials and shows chaotic behavior in terms of evolving structure. Synthesizing carbon materials largely depend on the deposition technique, process parameters, condition of substrate surface and…
We propose a numerical tool to mimic the pulsed deposition of nanoparticles, a technique used to fabricate thin films from the deposition of nanoparticles upon a substrate. We employ such tool under different initial conditions, in…
Thin film metallic glasses undergoing devitrification can form partially crystallized or fully crystallized materials with novel structural and magnetic properties. The development of desired and tunable properties of such systems drives…
Thin aluminum oxide films were deposited by a new and simple physicochemical method called chemical liquid phase deposition (CLD) on semiconductor materials. Aluminum sulfate with crystallized water and sodium bicarbonate were used as…
Nanocrystals of indium oxide (In$_2$O$_3$) with sizes below 10 nm were prepared in alumina matrixes by using a co-pulverization method. The used substrates such as borosilicate glasses or (100) silicon as well as the substrate temperatures…
Oblique angle deposited oxide thin films have opened up new dimensions in fabricating optical interference devices with tailored refractive index profile along thickness by tuning its microstructure by varying angle of deposition.…
If metal surfaces are exposed to sufficiently oxygen-rich environments, oxides start to form. Important steps in this process are the dissociative adsorption of oxygen at the surface, the incorporation of O atoms into the surface, the…
Synthesis of rationally designed nanostructured materials with optimized mechanical properties, e.g., high strength with considerable ductility, requires rigorous control of diverse microstructural parameters including the mean size, size…
This study was aimed to investigate the thickness dependent morphological changes of Mn films deposited on GaAs substrates by thermal evaporation technique. Ni films were deposited under same conditions to perform comparative study of the…
The present work is essentially focused on the study of optical and structural properties of hydrogenated amorphous silicon thin films (a-Si:H) prepared by radio-frequency cathodic sputtering. We examine separately the influence of hydrogen…
Al2O3 thin films have been deposited at substrate temperatures between 500{\deg}C to 600{\deg}C by reactive magnetron sputtering using an additional arbitrary substrate bias to tailor the energy distribution of the incident ions. The films…