Related papers: Beamforming Learning for mmWave Communication: The…
Recently, full duplex (FD) has been studied in 5G LTE millimeter wave (mmWave) cellular communications for New Radio in 3GPP releases 15-17. FD allows bidirectional transmission over the same resources and has the potential to reduce…
We propose a low-resolution analog-to-digital converter (ADC) module assisted hybrid beamforming architecture for millimeter-wave (mmWave) communications. We prove that the proposed low-cost and flexible architecture can reduce the beam…
The availability of large bandwidth at millimeter wave (mmWave) frequencies is one of the major factors that rendered very high frequencies a promising candidate enabler for fifth generation (5G) mobile communication networks. To confront…
Millimeter wave (mmWave) cellular systems will enable gigabit-per-second data rates thanks to the large bandwidth available at mmWave frequencies. To realize sufficient link margin, mmWave systems will employ directional beamforming with…
At millimeter wave (mmW) frequencies, beamforming and large antenna arrays are an essential requirement to combat the high path loss for mmW communication. Moreover, at these frequencies, very large bandwidths are available to fulfill the…
The utilization of millimeter wave frequency bands is expected to become prevalent in the following communication systems. However, generating and transmitting communication signals over these frequencies is not as straightforward as in…
In this paper, we propose a deep learning-based beam tracking method for millimeter-wave (mmWave)communications. Beam tracking is employed for transmitting the known symbols using the sounding beams and tracking time-varying channels to…
The codebook-based analog beamforming is appealing for future terahertz (THz) communications since it can generate high-gain directional beams with low-cost phase shifters via low-complexity beam training. However, conventional beamforming…
Communication systems at millimeter-wave (mmW) and sub-terahertz frequencies are of increasing interest for future high-data rate networks. One critical challenge faced by phased array systems at these high frequencies is the efficiency of…
Millimeter-wave (mmWave) and terahertz (THz) communications require beamforming to acquire adequate receive signal-to-noise ratio (SNR). To find the optimal beam, current beam management solutions perform beam training over a large number…
Millimeter-wave communications rely on narrow-beam transmissions to cope with the strong signal attenuation at these frequencies, thus demanding precise alignment between transmitter and receiver. However, the beam-alignment procedure may…
In this article, we study the joint communication and sensing (JCAS) paradigm in the context of millimeter-wave (mm-wave) mobile communication networks. We specifically address the JCAS challenges stemming from the full-duplex operation and…
Using multimodal sensory data can enhance communications systems by reducing the overhead and latency in beam training. However, processing such data incurs high computational complexity, and continuous sensing results in significant power…
Training beam design for channel estimation with infinite-resolution and low-resolution phase shifters (PSs) in hybrid analog-digital milimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems is considered in this paper.…
Beamforming is a signal processing technique. It has been studied in many areas such as radar, sonar, seismology and wireless communications, to name but a few. It can be used for a myriad of purposes, such as detecting the presence of a…
The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…
In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…
Millimeter-wave (mmWave) systems require a large number of antennas at both base station and user equipment for a desirable link budget. Due to time varying channel under user mobility, up-to-date channel state information (CSI) is critical…
Advancements in 6G wireless technology have elevated the importance of beamforming, especially for attaining ultra-high data rates via millimeter-wave (mmWave) frequency deployment. Although promising, mmWave bands require substantial beam…
Hybrid analog and digital BeamForming (HBF) is one of the enabling transceiver technologies for millimeter Wave (mmWave) Multiple Input Multiple Output (MIMO) systems. This technology offers highly directional communication, which is able…