Related papers: Single-Stage Regulated Resonant WPT Receiver with …
Transmission topology control is a tool used by system operators in the role of a control action taken into account as a preventive or corrective action relative to a specific outage or set of outages. However, their inclusion in most…
We study radio-frequency (RF) wireless power transfer (WPT) using a digital radio transmitter for applications where alternative analog transmit circuits are impractical. An important paramter for assessing the viability of an RF WPT system…
In conventional radar, the transmission of the same waveform is repeated after a predefined interval of time called pulse-repetition-interval (PRI). This technique helps to estimate the range and Doppler shift of targets and suppress…
The high tech industry which requires fast stable motion with nanometer precision continues to mainly use PID which is limited by fundamental linear control limitations. Floor vibrations as disturbance significantly affect performance and…
State of the Art Wireless Power Transfer (WPT) systems, based on conventional copper coils, are known to exhibit efficiencies well above 90% when operated in the resonantly coupled mid-range regime. Besides full system efficiency, the area-…
The operating frequency range of passive topological phononic crystals is generally fixed and narrow, limiting their practical applications. To overcome this difficulty, here we design and investigate a one-dimensional soft dielectric…
For enhancing power flow control in power transmission, a simplified new structure of direct power flow controller with continuous full regulation range (F-DPFC) was proposed. It has only one-stage power conversion and comprises of a…
This article is present high precision multiwave rectifier circuit operating in low voltage plus or minus 1.5 Volt current modes by CMOS technology 0.5 \mum, receive input and give output in current mode, respond at high frequency period.…
A microwave rectifier at 5.8 GHz without any capacitors is presented, which owns a measured MW-to-DC conversion efficiency of 68.1%. A harmonic rejection filter and a DC pass filter, which replace lumped capacitors in conventional microwave…
One of the primary goals of future wireless systems is to foster sustainability, for which, radio frequency (RF) wireless power transfer (WPT) is considered a key technology enabler. The key challenge of RF-WPT systems is the extremely low…
In ambient electromagnetic energy harvesting systems, the input power to the rectifier is low. To improve rectification efficiency, Schottky diodes, which are sensitive to low power, are commonly selected as rectifying devices to convert…
There is a trade-off between transient performance and line current distortion of the DC bus voltage control of single-phase grid-connected voltage source converters. This paper presents an improved DC bus voltage control scheme of such…
Wireless transfer of power via high frequency microwave radiation using a miniature split ring resonator rectenna is reported. RF power is converted into DC power by integrating a rectification circuit with the split ring resonator. The…
This paper presents a novel deep reinforcement learning (DRL)-based control strategy for achieving precise and robust output voltage regulation in LCC-S resonant converters, specifically designed for wireless power transfer applications.…
This article presents the main topics related to one-quadrant power converters. The basic topologies are analysed and a simple methodology to obtain the steady-state output-input voltage ratio is set out. A short discussion of different…
Employing low-resolution analog-to-digital converters (ADCs) for millimeter wave receivers with large antenna arrays provides opportunity to efficiently reduce power consumption of the receiver. Reducing ADC resolution, however, results in…
This paper presents a rigorous optimization technique for wireless power transfer (WPT) systems enhanced by passive elements, ranging from simple reflectors and intermedi- ate relays all the way to general electromagnetic guiding and…
We show how distributed control of reactive power can serve to regulate voltage and minimize resistive losses in a distribution circuit that includes a significant level of photovoltaic (PV) generation. To demonstrate the technique, we…
This paper addresses the problem of output voltage regulation for multiple DC-DC converters connected to a grid, and prescribes a robust scheme for sharing power among different sources. Also it develops a method for sharing 120 Hz ripple…
A novel room temperature capacitance-to-phase transducer is described, which uses a modified All-Pass filter architecture combined with a simple series resonant tank circuit with a moderate Q-factor. It is fashioned from a discrete inductor…