Related papers: Design Trade-offs for Decentralized Baseband Proce…
The performance of centralized and distributed massive MIMO deployments are analyzed for indoor office scenarios. The distributed deployments use one of the following precoding methods: (1) local precoding with local channel state…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
Analog-to-digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) communication systems with large number of antennas. Use of low resolution ADCs has been proposed as a means to…
Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…
The order-of-magnitude increase in the dimension of antenna arrays, which forms extra-large-scale massive multiple-input-multiple-output (MIMO) systems, enables substantial improvement in spectral efficiency, energy efficiency, and spatial…
This paper compares centralized and distributed methods to solve the power minimization problem with quality-of-service (QoS) constraints in the downlink (DL) of multi-cell Massive multiple-input multiple-output (MIMO) systems. In…
This paper considers a downlink cell-free multiple-input multiple-output (MIMO) network in which multiple multi-antenna access points (APs) serve multiple users via coherent joint transmission. In order to reduce the energy consumption by…
Realizing distributed multi-user beamforming (D-MUBF) in time division duplex (TDD)-based multi-user MIMO (MU-MIMO) systems faces significant challenges. One of the most fundamental challenges is achieving accurate over-the-air (OTA) timing…
High-mobility adaption and massive Multiple-input Multiple-output (MIMO) application are two primary evolving objectives for the next generation high speed train (HST) wireless communication system. In this paper, we consider how to design…
Future cellular systems based on the use of millimeter waves will heavily rely on the use of antenna arrays both at the transmitter and at the receiver. For complexity reasons and energy consumption issues, fully digital precoding and…
We investigate joint bistatic positioning (BP) and monostatic sensing (MS) within a multi-input multi-output orthogonal frequency-division system. Based on the derived Cram\'er-Rao Bounds (CRBs), we propose novel beamforming optimization…
Utilization of inter-base station cooperation for information processing has shown great potential in enhancing the overall quality of communication services (QoS) in wireless communication networks. Nevertheless, such cooperations require…
Cell-free massive multiple-input multiple-output (MIMO) is an emerging technology that will reshape the architecture of next-generation networks. This paper considers the sequential fronthaul, whereby the access points (APs) are connected…
We consider the multi-cell uplink (network MIMO) where M base-stations (BSs) communicate simultaneously with M user terminals (UTs). Although the potential benefit of multi-cell cooperation increases with M, the overhead related to learning…
Cell-free Massive MIMO is considered as a promising technology for satisfying the increasing number of users and high rate expectations in beyond-5G networks. The key idea is to let many distributed access points (APs) communicate with all…
This paper investigates a six-dimensional movable antenna (6DMA)-aided cell-free multi-user multiple-input multiple-output (MIMO) communication system. In this system, each distributed access point (AP) can flexibly adjust its array…
Densification of network base stations is indispensable to achieve the stringent Quality of Service (QoS) requirements of future mobile networks. However, with a dense deployment of transmitters, interference management becomes an arduous…
Multiple-antenna systems is a key technique to serve multiple users in future wireless systems. For low energy consumption and hardware complexity we first consider transmit symbols with constant magnitude and then 1-bit digital-to-analog…
Massive multiuser multiple-input multiple-output (MU-MIMO) has been the mainstream technology in fifth-generation wireless systems. To reduce high hardware costs and power consumption in massive MU-MIMO, low-resolution digital-to-analog…
In conventional multi-user multiple-input multiple-output (MU-MIMO) systems with frequency division duplexing (FDD), channel acquisition and precoder optimization processes have been designed separately although they are highly coupled.…