Related papers: Foil Scattering Model for Fermilab Booster
The Booster Neutrino Experiment (MiniBooNE) searches for numu-to-nue oscillations using the O(1 GeV) neutrino beam produced by the Booster synchrotron at the Fermi National Accelerator Laboratory (FNAL). The Booster delivers protons with 8…
The measurement of beam emittances by extracting the quadrupole mode signal from a 4 plate beam position monitor (BPM) was published at least 40 years ago. Unfortunately, in practice, this method suffers from poor signal to noise ratio and…
We present a new conceptual and optical design for the Next Linear Collider post-linac collimation system. Energy collimation and passive protection against off-energy beams are achieved in a system with large horizontal dispersion and…
The energy of a bunched non-relativistic ion beam can be deduced from measuring the beam phases in neighbouring Beam Position Monitors (BPMs). This report discusses implementation of such a procedure at the PIP-II H- linac being constructed…
Transverse instabilities of the antiproton beam have been observed in the Recycler ring soon after its commissioning. After installation of transverse dampers, the threshold for the instability limit increased significantly but the…
The Hefei Advanced Light Facility (HALF) will be a VUV and soft X-ray diffraction-limited storage ring (DLSR), and its high density of electron bunches makes the intra-beam scattering (IBS) effect very serious. In this paper, an IBS module…
The ion injectors of the CERN accelerator chain, in particular the Super Proton Synchrotron (SPS) and the Low Energy Ion Ring (LEIR), operate in a strong space charge~(SC) and intrabeam scattering (IBS) regime, which can degrade beam…
XL-Calibur is a balloon-borne Compton polarimeter for X-rays in the $\sim$15-80 keV range. Using an X-ray mirror with a 12 m focal length for collecting photons onto a beryllium scattering rod surrounded by CZT detectors, a…
We present recent beam data from a new design of a profile monitor for proton beams at Fermilab. The monitors, consisting of grids of segmented Ti foils 5micrometers thick, are secondary-electron emission monitors (SEM's). We review data on…
We present a generalization of the notoriously unwieldy second-order scattering fading model, which is helpful to alleviate its mathematical complexity while providing an additional degree of freedom. This is accomplished by allowing its…
Precise, accurate neutrino flux predictions for neutrino beam experiments are crucial for physics results. Flux predictions for the Booster Neutrino Beam at Fermilab were first published in 2009 by the MiniBooNE collaboration. It is no…
Fermilab's Superconducting RF Beam Test Facility currently under construction will produce electron beams capable of damaging the acceleration structures and the beam line vacuum chambers in the event of an aberrant accelerator pulse. The…
Quasielastic scattering excitation function at large backward angle has been measured for the weakly bound system, $^{7}$Li+$^{159}$Tb at energies around the Coulomb barrier. The corresponding quasielastic barrier distribution has been…
As the pre-injector of the LHC injector chain, the proton linac at CERN is required to provide a high-intensity (180mA) beam to the Proton Synchrotron Booster. The results of measurements at this intensity will be presented. Furthermore,…
Scattering processes in an optical microcavity are investigated for the case of silicon nanocrystals embedded in an ultra-high Q toroid microcavity. Using a novel measurement technique based on the observable mode-splitting, we demonstrate…
In-orbit experience has shown that soft protons are funneled more efficiently through focusing Wolter-type optics of X-ray observatories than simulations predicted. These protons can degrade the performance of solid-state X-ray detectors…
Compton scattering by the proton has been measured over a wide range covering photon energies 250 MeV < E_\gamma < 800 MeV and photon scattering angles 30^0 < \theta^{lab}_\gamma < 150^0, using the tagged-photon facility at MAMI (Mainz) and…
A pinned-free beam in axial fluid flow, subjected to feedback-based actuation at the pinned end, is investigated. The actuation may be a moment or a prescribed angle and it is proportional to the state (curvature, slope, or displacement) of…
We have performed a series of experiments at Fermilab to explore the electron cloud phenomenon. The Main Injector will have its beam intensity increased four-fold in the Project X upgrade, and would be subject to instabilities from the…
Beam breakup instability is a potential issue for all particle accelerators and is often the limiting factor for the maximum beam current that can be achieved. This is particularly relevant for Energy Recovery Linacs with multiple passes…