Related papers: Continuous Phase Modulation With 1-Bit Quantizatio…

In this paper, we consider a two-way relay network in which two users exchange messages through a single relay using a physical-layer network coding (PNC) based protocol. The protocol comprises two phases of communication. In the multiple…

Massive multiple-input multiple-output (MIMO) can improve the overall system performance significantly. Massive MIMO systems, however, may require a large number of radio frequency (RF) chains that could cause high cost and power…

Generalized product codes (GPCs) are extensions of product codes (PCs) where coded bits are protected by two component codes but not necessarily arranged in a rectangular array. It has recently been shown that there exists a large class of…

Spatial coupling is utilized to improve the performance of iterative channel estimation, multiuser detection, and decoding for multiple-input multiple-input (MIMO) bit-interleaved coded modulation (BICM). Coupling is applied to both coding…

This paper focuses on solving a challenging problem of blind deconvolution demixing involving modulated inputs. Specifically, multiple input signals $s_n(t)$, each bandlimited to $B$ Hz, are modulated with known random sequences $r_n(t)$…

Modulation recognition is a challenging task while performing spectrum sensing in a cognitive radio setup. Recently, the use of deep convolutional neural networks (CNNs) has shown to achieve state-of-the-art accuracy for modulation…

In this paper, we provide a new approach to the analytical estimation of the bit-error rate (BER) for convolutional codes for Viterbi decoding in the binary symmetric channel (BSC). The expressions we obtained for lower and upper BER bounds…

This paper considers a multiple-input multiple-output (MIMO) system with low-resolution analog-to-digital converters (ADCs). In this system, the paper presents a new MIMO detection approach using coding theory. The principal idea of the…

We develop a method to jointly estimate the carrier frequency offset (CFO) and the narrowband channel in millimeter wave (mmWave) MIMO systems operating with one-bit analog-to-digital converters (ADCs). We assume perfect timing…

This paper considers uplink massive MIMO systems with 1-bit analog-to-digital converters (ADCs) and develops a deep-learning based channel estimation framework. In this framework, the prior channel estimation observations and deep neural…

In this paper, we consider the one-bit precoding problem for the multiuser downlink massive multiple-input multiple-output (MIMO) system with phase shift keying (PSK) modulation. We focus on the celebrated constructive interference…

This paper considers a wideband millimeter-wave MIMO system with fully digital transceivers at both the base station and the user equipment (UE), focusing on mobile scenarios. To reduce the baseband processing burden at the UE, we propose a…

In this paper, we consider quantized decoding of LDPC codes on the binary symmetric channel. The binary message passing algorithms, while allowing extremely fast hardware implementation, are not very attractive from the perspective of…

In this paper, we propose a new class of bit flipping algorithms for low-density parity-check (LDPC) codes over the binary symmetric channel (BSC). Compared to the regular (parallel or serial) bit flipping algorithms, the proposed…

This paper considers channel estimation and system performance for the uplink of a single-cell massive multiple-input multiple-output (MIMO) system. Each receive antenna of the base station (BS) is assumed to be equipped with a pair of…

This paper considers a multipair amplify-and-forward massive MIMO relaying system with one-bit ADCs and one-bit DACs at the relay. The channel state information is estimated via pilot training, and then utilized by the relay to perform…

The maximum information rates for bandlimited channels with direct detection are achieved with joint detection and decoding (JDD), but JDD is often too complex to implement. Two receiver structures are studied to reduce complexity: separate…

With the development of high-definition display devices, the practical scenario of Super-Resolution (SR) usually needs to super-resolve large input like 2K to higher resolution (4K/8K). To reduce the computational and memory cost, current…

Non-stationary signals are ubiquitous in real life. Many techniques have been proposed in the last decades which allow decomposing multi-component signals into simple oscillatory mono-components, like the groundbreaking Empirical Mode…

The Terahertz band holds a promise to enable both super-accurate sensing and ultra-fast communication. However, challenges arise that severe Doppler effects call for a waveform with high Doppler robustness while severe propagation path loss…