Related papers: Hybrid Beamforming for Active Sensing using Sparse…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
This paper investigates the energy-efficient hybrid beamforming design for a multi-functional integrated sensing, communications, and powering (ISCAP) system. In this system, a base station (BS) with a hybrid analog-digital (HAD)…
In near-field beam focusing for finite-sized arrays, focal shift is a non-negligible issue. The actual focal point often appears closer to the array than the predefined focal distance, significantly degrading the focusing performance of…
Sonography techniques use multiple transducer elements for tissue visualization. Signals detected at each element are sampled prior to digital beamforming. The sampling rates required to perform high resolution digital beamforming are…
In mmWave massive multiple-input multiple-output (mMIMO) systems, hybrid digital/analog beamforming has been recognized as an economic means to overcome the severe mmWave propagation loss. To facilitate beamforming for mmWace mMIMO, there…
Hybrid beamforming (HBF) includes analog beamforming with phase shifted array in RF domain and digital beamforming in baseband domain. Phase shifted array is usually made up with a large amount of phase shifters. Limited to the…
Hybrid beamforming is a promising technology for 5G millimetre-wave communications. However, its implementation is challenging in practical multiple-input multiple-output (MIMO) systems because non-convex optimization problems have to be…
Hybrid multiple-input multiple-output (MIMO) is an attractive technology for realizing extreme massive MIMO systems envisioned for future wireless communications in a scalable and power-efficient manner. However, the fact that hybrid MIMO…
In this letter, we consider hybrid beamforming for millimeter wave (mmWave) MIMO integrated sensing and communications (ISAC). We design the transmit beam of a dual-functional radar-communication (DFRC) base station (BS), aiming at…
Currently prevalent multimodal 3D detection methods are built upon LiDAR-based detectors that usually use dense Bird's-Eye-View (BEV) feature maps. However, the cost of such BEV feature maps is quadratic to the detection range, making it…
Distributed phased Multiple-Input Multiple-Output (phased-MIMO) radar systems have attracted wide attention in target detection and tracking. However, the phase-shifting circuits in phased subarrays contribute to high power consumption and…
We investigate the beam squint effect in uniform planar arrays (UPAs) and propose an efficient hybrid beamforming (HBF) design to mitigate the beam squint in multiple-input multiple-output orthogonal frequency-division multiplexing…
Millimeter wave communications require multibeam beamforming in order to utilize wireless channels that suffer from obstructions, path loss, and multi-path effects. Digital multibeam beamforming has maximum degrees of freedom compared to…
Conventional hybrid beamforming architectures are often compared with one another and with the fully-digital architecture under the same \emph{radiated} antenna power. However, the physically relevant budget is the power injected by the…
At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…
Millimeter wave (mmWave) communication, utilizing beamforming techniques to address the inherent path loss limitation, is considered as one of the key technologies to support ever increasing high throughput and low latency demands of…
In this paper we present a novel beamforming technique that can be used with an array of quantum sensors. The transmit waveform is a short-duration frequency comb constructed using a finite number of sinusoidal tones separated by a fixed…
Hybrid multiple-antenna transceivers, which combine large-dimensional analog pre/postprocessing with lower-dimensional digital processing, are the most promising approach for reducing the hardware cost and training overhead in massive MIMO…
Ultrasound imaging faces a trade-off between image quality and hardware complexity caused by dense transducers. Sparse arrays are one popular solution to mitigate this challenge. This work proposes an end-to-end optimization framework that…
Network connectivity is one of the major design issues in the context of mobile sensor networks. Due to diverse communication patterns, some nodes lying in high-traffic zones may consume more energy and eventually die out resulting in…