Related papers: PAPR-Limited Precoding in Massive MIMO Systems wit…
Low-resolution analog-to-digital converters (ADCs) simplify the design of millimeter-wave (mmWave) massive multi-user multiple-input multiple-output (MU-MIMO) basestations, but increase vulnerability to jamming attacks. As a remedy, we…
Hybrid beamforming has been widely employed in mmWave communications such as vehicular-to-everything (V2X) scenarios, as a compromise between hardware complexity and spectral efficiency. However, the inherent coupling between analog and…
Massive multi-user multiple-input multiple-output (MU-MIMO) wireless systems operating at millimeter-wave (mmWave) frequencies enable simultaneous wideband data transmission to a large number of users. In order to reduce the complexity of…
The D-band offering an untapped wide bandwidth is promising for high data rate communication and high-resolution wireless sensing. However, these potentials are hindered by the low performance and energy efficiency of the D-band circuits…
Hybrid multiple-antenna transceivers, which combine large-dimensional analog pre/postprocessing with lower-dimensional digital processing, are the most promising approach for reducing the hardware cost and training overhead in massive MIMO…
To meet the demands of future wireless networks, antenna arrays must scale from massive multiple-input multiple-output (MIMO) to gigantic MIMO, involving even larger numbers of antennas. To address the hardware and computational cost of…
Multiple-input multiple-output (MIMO) systems greatly increase the overall throughput of wireless systems since they are capable of transmitting multiple streams employing the same time-frequency resources. However, this gain requires an…
To keep massive MIMO systems cost-efficient, power amplifiers with rather small output dynamic ranges are employed. They may distort the transmit signal and degrade the performance. This paper proposes a distortion aware precoding scheme…
Large propagation path loss and limited scattering of millimeter wave (mmwave) channels create new challenges for physical layer signal processing. Hence, in this article, we propose a photonic hybrid precoding model for mmwave…
The capacity of commercial massive multiple-input multiple-output (mMIMO) systems is constrained by the limited array aperture at the base station, and cannot meet the ever-increasing traffic demands of wireless networks. Given the array…
Low-resolution analog-to-digital converters (ADCs) and hybrid beamforming have emerged as efficient solutions to reduce power consumption with satisfactory spectral efficiency (SE) in massive multiple-input multiple-output (MIMO) systems.…
This paper focuses on the joint design of transmit waveforms and receive filters for airborne multiple-input-multiple-output (MIMO) radar systems in spectrally crowded environments. The purpose is to maximize the output…
In this paper, we focus on reduced complexity full duplex Multiple-Input Multiple-Output (MIMO) systems and present a joint design of digital transmit and receive beamforming with Analog and Digital (A/D) self-interference cancellation. We…
The deployment of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems cannot rely solely on digital precoding due to hardware constraints. Instead, hybrid precoding, which combines digital and radio frequency (RF)…
Due to the power consumption and high circuit cost in antenna arrays, the practical application of massive multiple-input multiple-output (MIMO) in the sixth generation (6G) and future wireless networks is still challenging. Employing…
In this paper, we propose a hybrid analog-digital beamforming architecture with resolution-adaptive ADCs for millimeter wave (mmWave) receivers with large antenna arrays. We adopt array response vectors for the analog combiners and derive…
As communication systems that employ millimeter wave (mmWave) frequency bands must use large antenna arrays to overcome the severe propagation loss of mmWave signals, hybrid beamforming has been considered as an integral component of mmWave…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
A variable-phase-shifter (VPS) architecture with hybrid precoding for mixture use of phase shifters and switches, is proposed for millimeter wave massive multiple-input multiple-output communications. For the VPS architecture, a hybrid…
Dynamic subarray achieves a compromise between sum rate and hardware complexity for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems in which antenna elements are dynamically partitioned to radio frequency (RF)…