Related papers: Intra-Pulse Polyphase Coding System for Second Tri…
Detection and classification of radars based on pulses they transmit is an important application in electronic warfare systems. In this work, we propose a novel deep-learning based technique that automatically recognizes intra-pulse…
A polarimetric synthetic aperture radar (PolSAR) system, which uses multiple images acquired with different polarizations in both transmission and reception, has the potential to improve the description and interpretation of the observed…
In this paper, we shed light on how an adaptive, efficient error coding in the transport layer helps ensure the application requirements. We recap the use of MDS codes and show that binary coding can significantly reduce the complexity and…
We consider the design of polyphase waveforms for ground moving target detection with airborne multiple-input-multiple-output (MIMO) radar. Due to the constant-modulus and finite-alphabet constraint on the waveforms, the associated design…
Doppler radars are routinely used for the remote sensing of oceanic surface currents and atmospheric wind profiles. Even though they operate at different frequencies and address different media, they follow very similar processing for the…
In this paper, power allocation is examined for the coexistence of a radar and a communication system that employ multicarrier waveforms. We propose two designs for the considered spectrum sharing problem by maximizing the output…
Intelligent reflecting surface (IRS) is recognized as an enabler of future dual-function radar-communications (DFRC) by improving spectral efficiency, coverage, parameter estimation, and interference suppression. Prior studies on IRS-aided…
This paper focuses on the joint design of transmit waveforms and receive filters for airborne multiple-input-multiple-output (MIMO) radar systems in spectrally crowded environments. The purpose is to maximize the output…
This article develops the applicability of non-linear processing techniques such as Compressed Sensing (CS), Principal Component Analysis (PCA), Iterative Adaptive Approach (IAA) and Multiple-input-multiple-output (MIMO) for the purpose of…
In multiple-input and multiple-output (MIMO) radar systems based on Doppler-division multiplexing (DDM), phase shifters are employed in the transmit paths and require calibration strategies to maintain optimal performance all along the…
Three-dimensional device integration facilitates the construction of superconducting quantum information processors with more than several tens of qubits by distributing elements such as control wires, qubits, and resonators between…
Pulse Doppler radars suffer from range-Doppler ambiguity that translates into a trade-off between maximal unambiguous range and velocity. Several techniques, like the multiple PRFs (MPRF) method, have been proposed to mitigate this problem.…
To enhance the resource scheduling performance of phased array radar, we propose a dynamic adaptive resource scheduling algorithm based on synthesis priorities and pulse interleaving. This approach addresses the challenges of low…
Concealing objects from interrogation has been a primary objective since the integration of radars into surveillance systems. Metamaterial-based invisibility cloaking, which was considered a promising solution, did not yet succeed in…
Polarimetric phased arrays (PPAs) enhance radar target detection and anti-jamming capabilities, but their conventional dual transmit/receive (T/R) channel architecture leads to high cost and system complexity. To address these limitations,…
Polarimetry is about to become a powerful tool for determining the atmospheric properties of exoplanets. To provide the basis for the interpretation of observational results and for predictive studies to guide future observations,…
An accurate delay and Doppler estimation method for a radar system using time and frequency-shifted pulses with pseudo-random numbers is proposed. The ambiguity function of the transmitted signal has a strong peak at the origin and is close…
The recently proposed orthogonal time frequency space (OTFS) modulation multiplexes data symbols in the delay-Doppler (DD) domain. Since the range and velocity, which can be derived from the delay and Doppler shifts, are the parameters of…
We present a novel three-dimensional (3D) imaging approach that combines two-dimensional spatial Fourier-domain imaging techniques with traditional radar pulse compression to recover both cross-range and down-range scene information. The…
Aims: We present POLARIS (POLArized RadIation Simulator), a newly developed three-dimensional Monte-Carlo radiative transfer code. POLARIS was designed to calculate dust temperature, polarization maps, and spectral energy distributions. It…