Related papers: Rate-Splitting for Multigroup Multicast Beamformin…
Rate-splitting multiple access (RSMA) is a multiple access scheme to mitigate the effects of the multi-user interference (MUI) in multi-antenna systems. In this study, we leverage the interference management capabilities of RSMA to tackle…
Immersive video, such as virtual reality (VR) and multi-view videos, is growing in popularity. Its wireless streaming is an instance of general multicast, extending conventional unicast and multicast, whose effective design is still open.…
In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…
This paper deals with the problem of beamforming design in a multibeam satellite, which is shared by different groups of terminals -clusters-, each served by an Earth station or gateway. Each gateway precodes the symbols addressed to its…
Joint radar-communications (JRC) benefits from multi-functionality of radar and communication operations using same hardware and radio frequency (RF) spectrum resources. Thus JRC systems possess very high potential to be employed into the…
We propose a multicast scheduling scheme to exploit content reuse when there is asynchronicity in user requests. A unicast transmission setup is used for content delivery, while multicast transmission is employed opportunistically to reduce…
This article addresses the design of multigroup multicast communications in the pinching-antenna system (PASS). A PASS-enabled multigroup transmission framework is proposed to maximize multicast rates under a couple of transmission…
We analyze a MISO downlink channel where a multi-antenna transmitter communicates with a large number of single-antenna receivers. Using linear beamforming or nonlinear precoding techniques, the transmitter can serve multiple users…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
The use of the millimeter (mm) wave spectrum for next generation (5G) mobile communication has gained significant attention recently. The small carrier wavelengths at mmwave frequencies enable synthesis of compact antenna arrays, providing…
This article investigates secure multicast communications in pinching-antenna systems (PASS), where pinching beamforming is enabled by adaptively adjusting pinching antenna (PAs) positions along waveguides to improve multicast security.…
In this paper we explore the use of full-duplex radio to improve the spectrum efficiency in a two-way relay channel where two sources exchange information through an multi-antenna relay, and all nodes work in the full-duplex mode. The…
The integrated design of communication and sensing may offer a potential solution to address spectrum congestion. In this work, we develop a beamforming method for a dual-function radar-communication system, where the transmit signal is…
Broadcasting/multicasting is an efficient mechanism for multimedia communications due to its high spectrum efficiency, which achieves point-to-multipoint transmission on the same radio resources. To satisfy the increasing demands for…
This paper studies multi-satellite multi-stream (MSMS) beamspace transmission, where multiple satellites cooperate to form a distributed multiple-input multiple-output (MIMO) system and jointly deliver multiple data streams to multi-antenna…
An analysis of the diversity gain for bit-interleaved coded multiple beamforming (BICMB) method in millimeter-wave (mm-Wave) massive multiple-input multiple-output (MIMO) systems is carried out for both the single-user and multi-user…
Multi-cell wireless systems usually suffer both intra-cell and inter-cell interference, which can be mitigated via coordinated multipoint (CoMP) techniques. Previous works on multi-cell analysis for the microwave band generally consider…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
Massive multi-input multi-output (MIMO) uses a very large number of low-power transmit antennas to serve much smaller numbers of users. The most widely proposed type of massive MIMO transmit beamforming is zero-forcing, which is based on…
Coded caching (CC) techniques have been shown to be conveniently applicable in multi-input multi-output (MIMO) systems. In a $K$-user network with spatial multiplexing gains of $L$ at the transmitter and $G$ at every receiver, if each user…