Related papers: A Direct- Conversion Digital Beamforming Array Rec…

Integrated optical transceivers, utilizing wavelength-division-multiplexing, offer a path forward for implementation of compact, high-bandwidth and energy-efficient interconnects for future data centers. Here we report the demonstration of…

This paper investigates the design of analog beamforming at the receiver in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, aided by full digital chains featuring 1-bit ADCs. We advocate utilizing these full digital…

This paper proposes a high-speed transceiver-based method for implementing a digital-to-time converter (DTC). A real-time decoding technique is introduced to inject time information into high-speed pattern data. The stability of the…

We demonstrate a complete Silicon Photonics WDM link relying on a single section semiconductor mode-locked laser and a single SOA to support up to 12 multiplexed channels with a bit error rate of 1e-12 at serial data rates of 14 Gbps…

A high-resolution time-to-digital converter (TDC) based on wave union (four-edge WU A), dual-sampling, and sub-TDL methods is proposed and implemented in a 16-nm Xilinx UltraScale+ field-programmable gate array (FPGA). We combine WU and…

The Submillimeter Array (SMA), a collaboration between the Smithsonian Astrophysical Observatory and the Academica Sinica Institute for Astronomy and Astrophysics of Taiwan, is an eight-element radio-interferometer designed to operate…

Analog to digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) receivers in large bandwidth millimeter-wave systems. Prior works have considered two mitigating solutions to…

A pre-requisite for the design of wireless systems is the understanding of the propagation channel. While a wealth of propagation knowledge exists for bands below 6 GHz, the same can not be said for bands approaching millimeter-wave…

Digital Signal Processing functions are widely used in real time high speed applications. Those functions are generally implemented either on ASICs with inflexibility, or on FPGAs with bottlenecks of relatively smaller utilization factor or…

Broadband beamforming is a technique to obtain the signal with a wide range of frequencies. It maintains the signal integrity and spatial selectivity over frequencies. This is important in several applications such as microphone array,…

In this paper, we analytically design a simple configuration of a broadband THz and polarization-insensitive absorber. The mentioned absorber consists of two layers of graphene disks, and the transmission line model is considered for the…

Data center interconnects (DCIs) will have to support throughputs of 400 Gbps or more per wavelength in the near future. To achieve such high data rates, coherent modulation and detection is used, which conventionally requires high-speed…

Flat-top beam designs are essential for uniform power distribution over a wide angular sector for applications such as 5G/6G networks, beaconing, satellite communications, radar systems, etc. Low sidelobe levels with steep transitions allow…

Dual-function radar communications (DFRC) systems have recently been proposed to enable the coexistence of radar and wireless communications, which in turn alleviates the increased spectrum congestion crisis. In this paper, we consider the…

Next generation communication and sensing require enabling technologies for miniaturized and efficient heterogeneous systems while integrating technologies ranging from silicon to compound semiconductors and from photonic chips to…

An X-ray detector will be presented that is the combination of a segmented ionization chamber featuring one-dimensional spatial resolution integrated with an intelligent ADC front-end, multi DSP processing and embedded PC platform. This…

A Microstrip patch array antenna has been designed for 5.62 GHz on FR4 substrate having a dielectric constant of 4.4 and thickness is 1.6 mm.The antenna is used to design for use with a low cost imaging radar MicroSAR. The antenna composed…

We are developing a new readout board with a newer generation field-programmable gate array (FPGA) and the 10-gigabit ethernet to improve the performance and usability of the current readout board based on the 1-gigabit Ethernet. In this…

The design of a conical phased array antenna for air traffic control (ATC) radar systems is addressed in this work. The array, characterized by a fully digital beam-forming (DBF) architecture, is composed of equal vertical modules…

Dynamic Metasurface Antennas (DMAs) have been recently proposed as a cost- and energy-efficient front-end solution for eXtremely Large (XL) antenna array systems, supporting scalable Analog and Digital (A/D) beamforming while using a…