Related papers: Optimized proximity thermometer for ultra-sensitiv…
We present radio-frequency thermometry based on a tunnel junction between a superconductor and proximitized normal metal. It allows operation in a wide range of biasing conditions. We demonstrate that the standard finite-bias quasiparticle…
We discuss inherent thermometry in a Superconductor - Normal metal - Superconductor tunnel junction. In this configuration, the energy selectivity of single-particle tunneling can provide a significant electron cooling, depending on the…
We propose a mesoscopic thermometer for ultrasensitive detection based on the proximity effect in superconductor-normal metal (SN) heterostructures. The device is based on the zero-bias anomaly due to the inelastic Cooper pair tunneling in…
The temperature dependence of the I-V characteristics of many single-electron tunneling devices enable thermometer operation of these systems. We investigate two normal conducting kinds of them, {\sl (a)} a single junction in a…
A proximity-effect thermometer measures the temperature dependent critical supercurrent in a long superconductor - normal metal - superconductor (SNS) Josephson junction. Typically, the transition from the superconducting to the normal…
We have successfully fabricated Cu/AlOx-Al/Nb normal-metal/insulator/superconductor tunnel junction devices with a high value of the superconducting gap (up to $\sim 1$ mV), using electron-beam lithography and angle evaporation techniques…
We investigate a wafer scale tunnel junction fabrication method, where a plasma etched via through a dielectric layer covering bottom Al electrode defines the tunnel junction area. The ex-situ tunnel barrier is formed by oxidation of the…
We present a simple on-chip electronic thermometer with the potential to operate down to 1 mK. It is based on transport through a single normal-metal - superconductor tunnel junction with rapidly widening leads. The current through the…
The qualities of electron refrigeration by means of tunnel junctions between superconducting and normal--metal electrodes are studied theoretically. A suitable approximation of the basic expression for the heat current across those tunnel…
We present a measurement and analysis scheme for determining traceable thermodynamic temperature at cryogenic temperatures using Coulomb blockade thermometry. The uncertainty of the electrical measurement is improved by utilizing two…
We demonstrate an original method -- based on controlled oxidation -- to create high-quality tunnel junctions between superconducting Al reservoirs and InAs semiconductor nanowires. We show clean tunnel characteristics with a current…
Hybrid normal metal - insulator - superconductor microstructures suitable for studying an interference of electrons were fabricated. The structures consist of a superconducting loop connected to a normal metal electrode through a tunnel…
At low temperatures, the transport through a superconducting-normal tunnel interface is due to tunneling of electrons in pairs. The probability for this process is shown to depend on the layout of the electrodes near the tunnel junction,…
We have measured current-voltage characteristics of two-dimensional arrays of small tunnel junctions at temperatures from 1.5 K to 4.2 K. This corresponds to thermal energies larger than the charging energy. We show that 2D-arrays can be…
Transition Edge Sensors are ultra-sensitive superconducting detectors with applications in many areas of research, including astrophysics. The device consists of a superconducting thin film, often with additional normal metal features, held…
We couple a proximity Josephson junction to a Joule-heated normal metal film and measure its electron temperature under steady state and nonequilibrium conditions. With a timed sequence of heating and temperature probing pulses, we are able…
We investigate a quadruple quantum dot setup that can be employed to sense the temperature of an electrically isolated remote target reservoir. Such a setup was conceived earlier by S\'anchez et. al. (New Journal of Physics, 19, 113040) as…
In mesoscopic superconductor/normal-metal/superconductor (SNS) heterostructures, it is known that the resistance of the normal metal between the superconductors has a strong temperature dependence. Based on this phenomenon, we have…
Using the strong temperature dependent resistance of a normal metal wire in proximity to a superconductor, we have been able to measure the local temperature of electrons heated by flowing a dc current in a metallic wire to within a few…
We have investigated theoretically the effects of the charging energy to the normal metal--insulator--superconductor (NIS) tunnel junction used as a thermometer. We demonstrate by numerical calculations how the charging effects modify NIS…