Related papers: Transmission Lines Positive Sequence Parameters Es…
With the proposition to install a large number of phasor measurement units (PMUs) in the future power grid, it is essential to provide robust communications infrastructure for phasor data across the network. We make progress in this…
We consider a power transmission system monitored with Phasor Measurement Units (PMUs) placed at significant, but not all, nodes of the system. Assuming that a sufficient number of distinct single-line faults, specifically pre-fault state…
In this document, the supervisory control and data acquisition (SCADA) and phasor measurement unit (PMU) measurement chain modeling will be studied, where the measurement error sources of each component in the SCADA and PMU measurement…
An equivalent circuit formulation for power system analysis was demonstrated to improve robustness of Power Flow and enable more generalized modeling, including that for RTUs (Remote Terminal Units) and PMUs (Phasor Measurement Units).…
Phasor measurement units (PMUs) have the advantage of providing direct measurements of power states. However, as the number of PMUs in a power system is limited, the traditional supervisory control and data acquisition (SCADA) system cannot…
This paper presents a novel parameter calibration approach for power system stability models using automatic data generation and advanced deep learning technology. A PMU-measurement-based event playback approach is used to identify…
The statistical characterization of the measurement errors of a phasor measurement unit (PMU) is currently receiving considerable interest in the power systems community. This paper focuses on the characteristics of the errors in magnitude…
This paper proposes a method of identifying single line outages in power systems based on phasor measurement unit (PMU) measurements and ac power flow models. In addition to the main identification algorithm, a rejection filter is…
Dynamic state and parameter estimation methods for dynamic security assessment in power systems are becoming increasingly important for system operators. Usually, the data used for this type of applications stems from phasor measurement…
Wide-area data and algorithms in large power systems are creating new opportunities for implementation of measurement-based dynamic load modeling techniques. These techniques improve the accuracy of dynamic load models, which are an…
We describe a simple method to experimentally determine the frequency dependencies of the per-unit-length resistance and conductance of transmission lines. The experiment is intended as a supplement to the classic measurement of the…
The power system state estimation (SE) algorithm estimates the complex bus voltages based on the available set of measurements. Because phasor measurement units (PMUs) are becoming more widely employed in transmission power systems, a fast…
Real-time transmission line outage detection is difficult because of partial phasor measurement unit (PMU) deployment and varying outage signal strength. Existing detection approaches focus on monitoring PMU-measured nodal algebraic states,…
Since transmission lines are crucial links in the power system, one line outage event may bring about interruption or even cascading failure of the power system. If a quick and accurate line outage detection and localization can be…
In this article, we present a new model for a synchronous generator based on phasor measurement units (PMUs) data. The proposed sub-transient model allows to estimate the dynamic state variables as well as to calibrate model parameters. The…
In this paper, phasor measurement unit (PMU) placement for power grid state estimation under different degrees of observability is studied. Observability degree is the depth of the buses' reachability by the placed PMUs and thus constitutes…
As phasor measurement units (PMUs) become more widely used in transmission power systems, a fast state estimation (SE) algorithm that can take advantage of their high sample rates is needed. To accomplish this, we present a method that uses…
This study, conducted in 2017, explores the use of Machine learning algorithms to predict Characteristics of Transmission Lines such as Impedance or resonance frequency using design parameters of Transmission Lines. Using formulas and…
Phasor Measurement Unit (PMU) technology is increasingly used for real-time monitoring applications, especially line outage detection and identification (D&I) in the power system. Current outage D&I schemes either assume a full PMU…
Phasor measurement units (PMUs) provide high-fidelity data that improve situation awareness of electric power grid operations. PMU datastreams inform wide-area state estimation, monitor area control error, and facilitate event detection in…