Related papers: An N-Path Filter with Multiphase PWM Clocks for Ha…
Time-frequency representation (TFR) is often used for non-stationary signal analysis. The most intuitive and interpretable TFR is the spectrogram. Recently, a concept of non-negative matrix factorization (NMF) has been successfully applied…
Nonreciprocal conversion is essential for protecting sources and enabling unidirectional signal routing in photonic, phononic, electronics, and quantum systems, yet conventional implementations rely on magnetic bias that could be…
A new, programmed pulse width modulation (PWM) technique to control power inverters, which uses a harmonic injection modulator and a frequency modulated triangular carrier, synchronized with the modulating signal is presented in this paper.…
In practical applications, quantum systems are inevitably subject to significant uncertainties, including unknown initial states, imprecise physical parameters, and unmodeled environmental noise, all of which pose major challenges to robust…
It is demonstrated that non-resonant wave front reversal (WFR) of spin-wave pulses caused by pulsed parametric pumping can be effectively used for microwave signal processing. When the frequency band of signal amplification by pumping is…
Several strategies for nonlinearity mitigation based on signal processing at the transmitter and/or receiver side are analyzed and their effectiveness is discussed. Improved capacity lower bounds based on their combination are presented.
Echo cancellation and noise reduction are essential for full-duplex communication, yet most existing neural networks have high computational costs and are inflexible in tuning model complexity. In this paper, we introduce time-frequency…
A slow-light scheme is proposed for simultaneous frequency conversion and spectral compression of a weak optical pulse, which may be in any quantum state including a single-photon state. Such a process plays crucial roles in a number of…
Here we study a simple way of controlling the emitted fields of sub-wavelength nanometric sources. The system consists of arrays of nanoparticles (NPs) embedded in optical active media. The key concept is the careful tuning of NP's damping…
Time-reversal symmetry enables shaping input waves to control output waves in many linear and nonlinear systems; however energy dissipation violates such symmetry. We consider a saturated multimode fiber amplifier in which light generates…
High efficiency and a compact footprint are desired properties for electro-optic modulators. In this paper, we propose, theoretically investigate and experimentally demonstrate a recirculating phase modulator, which increases the modulation…
This paper presents a planar multimodal periodic filter that is constructed from alternating sections of coplanar stripline and the odd-mode of a finite-ground plane coplanar waveguide constructed on a 1 um silicon nitride substrate to…
Harmonic generation during radio frequency (RF)-dc conversion causes performance degradation of a microwave rectifying circuit. To suppress and recycle the harmonic power, this letter proposes a novel compact dual-band resonator (DBR) based…
A spatial-frequency thin-film filter with inclusions of nanoparticles operating in the visible range of the spectrum is investigated. The effect of nanoparticles embedded in the central and lateral layers of the frustrated total internal…
Photonic quantum computing is a strong contender in the race to fault-tolerance. Recent proposals using qubits encoded in frequency modes promise a large reduction in hardware footprint, and have garnered much attention. In this encoding,…
The low-pass filter is a classic control conditioning approach for high-frequency current-mode control. However, no existing literature discusses the large-signal stability criterion for the current-mode control with low-pass filters. This…
Digital filters with variable bandwidth can be used for a variety of applications. Arbitrary change in the bandwidth of a digital Finite Impulse Response (FIR) filter can be acquired using sampling rate converters. In this paper, a sampling…
When signals are measured through physical sensors, they are perturbed by noise. To reduce noise, low-pass filters are commonly employed in order to attenuate high frequency components in the incoming signal, regardless if they come from…
Quantum gates are typically vulnerable to imperfections in the classical control fields applied to physical qubits to drive the gates. One approach to reduce this source of error is to break the gate into parts, known as composite pulses…
A stepped-impedance low-pass filter with integrated hollow waveguide absorbers is presented. The filter combines low insertion loss in the passband with strong attenuation at high frequencies, making it well suited for superconducting…