Related papers: Deep Learning for Massive MIMO with 1-Bit ADCs: Wh…
We propose a novel low-resolution-aware recursive least squares channel estimation algorithm for uplink multi-user multiple-input multiple-output systems. In order to reduce the energy consumption, 1-bit ADCs are used on each receive…
The fundamental limits of communication over multiple-input multiple-output (MIMO) networks are considered when a limited number of one-bit analog to digital converters (ADC) are used at the receiver terminals. Prior works have mainly…
In a cell-free cloud radio access network (C-RAN) architecture, uplink channel estimation is carried out by a centralized baseband processing unit (BBU) connected to distributed remote radio heads (RRHs). When the RRHs have multiple…
In this letter, we derive an approximate analytical expression for the uplink achievable rate of a massive multi-input multi-output (MIMO) antenna system when finite precision analog-digital converters (ADCs) and the common maximal ratio…
Large scale multiple-input multiple-output (MIMO) or Massive MIMO is one of the pivotal technologies for future wireless networks. However, the performance of massive MIMO systems heavily relies on accurate channel estimation. While the…
In this paper, we propose a joint pilot design and channel estimation scheme based on the deep learning (DL) technique for multiuser multiple-input multiple output (MIMO) channels. To this end, we construct a pilot designer using two-layer…
This paper investigated the uplink of multi-user massive multi-input multi-output (MIMO) systems with a mixed analog-to-digital converter (ADC) receiver architecture, in which some antennas are equipped with costly full-resolution ADCs and…
Low-resolution analog-to-digital converters (ADCs) are promising for reducing energy consumption and costs of multiuser multiple-input multiple-output (MIMO) systems with many antennas. We propose low-resolution multiuser MIMO receivers…
The great potentials of massive Multiple-Input Multiple-Output (MIMO) in Frequency Division Duplex (FDD) mode can be fully exploited when the downlink Channel State Information (CSI) is available at base stations. However, the accurate CSI…
Receivers with one-bit analog-to-digital converters (ADCs) are promising for high bandwidth millimeter wave (mmWave) systems as they consume less power than their full resolution counterparts. The extreme quantization in one-bit receivers…
The use of one-bit analog-to-digital converter (ADC) has been considered as a viable alternative to high resolution counterparts in realizing and commercializing massive multiple-input multiple-output (MIMO) systems. However, the issue of…
The use of one-bit analog-to-digital converters (ADCs) at a receiver is a power-efficient solution for future wireless systems operating with a large signal bandwidth and/or a massive number of receive radio frequency chains. This solution,…
Using a very low-resolution analog-to-digital convertor (ADC) unit at each antenna can remarkably reduce the hardware cost and power consumption of a massive multiple-input multiple-output (MIMO) system. However, such a pure low-resolution…
In this paper, we investigate the capacity of massive multiple-input multiple-output (MIMO) systems corrupted by complex-valued additive white Gaussian noise (AWGN) when both the transmitter and the receiver employ 1-bit digital-to-analog…
This paper focuses on channel estimation for mmWave MIMO systems with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). The channel estimation performance with 1-bit spatial sigma-delta ADCs depends on the quantization noise…
We consider a cell-free massive multiple-input multiple-output (MIMO) system with multiple antennas on the users and access points (APs). In previous works, the downlink spectral efficiency (SE) has been evaluated using the hardening bound…
Learning-based algorithms have gained great popularity in communications since they often outperform even carefully engineered solutions by learning from training samples. In this paper, we show that the selection of appropriate training…
Multiple-input multiple-output (MIMO) wireless systems conventionally use high-resolution analog-to-digital converters (ADCs) at the receiver side to faithfully digitize received signals prior to digital signal processing. However, the…
Large-scale multiple-antenna systems have been identified as a promising technology for the next generation of wireless systems. However, by scaling up the number of receive antennas the energy consumption will also increase. One possible…
This paper presents an analytical framework for the data detection in massive multiple-input multiple-output uplink systems with 1-bit analog-to-digital converters (ADCs). Considering the single-user case, we provide closed-form expressions…