Related papers: Investigation of Channel Estimation Techniques wit…
The wide bandwidth and large number of antennas used in millimeter wave systems put a heavy burden on the power consumption at the receiver. In this paper, using an additive quantization noise model, the effect of analog-digital conversion…
This paper addresses the optimal design of limited-feedback downlink multi-user spatial multiplexing systems. A multiple-antenna base-station is assumed to serve multiple single-antenna users, who quantize and feed back their channel state…
In this letter, we investigate the downlink performance of massive multiple-input multiple-output (MIMO) systems where the base station is equipped with one-bit analogto-digital/digital-to-analog converters (ADC/DACs). Considering…
Massive MIMO is a variant of multiuser MIMO where the number of base-station antennas $M$ is very large (typically 100), and generally much larger than the number of spatially multiplexed data streams (typically 10). Unfortunately, the…
Reconfigurable antennas (RAs) are a promising technology to enhance the capacity and coverage of wireless communication systems. However, RA systems have two major challenges: (i) High computational complexity of mode selection, and (ii)…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
Future wireless multiple-input multiple-output (MIMO) communication systems will employ sub-6 GHz and millimeter wave (mmWave) frequency bands working cooperatively. Establishing a MIMO communication link usually relies on estimating…
In this paper, iterative multi-user detection techniques for multi-beam communications are presented. The solutions are based on a successive interference cancellation architecture and a channel decoding to treat the co-channel…
Communication systems with low-resolution analog-to-digital-converters (ADCs) can exploit channel state information at the transmitter (CSIT) and receiver. This paper presents initial results on codebook design and performance analysis for…
In this letter, we optimize the channel estimator of the cascaded channel in an intelligent reflecting surface (IRS)-assisted millimeter wave (mmWave) multi-antenna system. In this system, the receiver is equipped with a hybrid architecture…
Massive multi-antenna millimeter wave (mmWave) and terahertz wireless systems promise high-bandwidth communication to multiple user equipments in the same time-frequency resource. The high path loss of wave propagation at such frequencies…
Two-channel modulo analog-to-digital converters (ADCs) enable high-dynamic-range signal sensing at the Nyquist rate per channel, but existing designs quantise both channel outputs independently, incurring redundant bitrate costs. This paper…
Massive multiple-input multiple-output (M-MIMO) is an enabling technology of 5G wireless communication. The performance of an M-MIMO system is highly dependent on the speed and accuracy of obtaining the channel state information (CSI). The…
We study downlink (DL) channel estimation in a multi-cell Massive multiple-input multiple-output (MIMO) system operating in a time-division duplex. The users must know their effective channel gains to decode their received DL data signals.…
Massive multiple-input multiple-output (MIMO) is a promising technology for next generation wireless communication systems (5G). In this technology, Base Station (BS) is equipped with a large number of antennas. Employing high resolution…
In wideband millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems, channel estimation is challenging due to the hybrid analog-digital architecture, which compresses the received pilot signal and makes channel…
We propose sparsity-adaptive beamspace channel estimation algorithms that improve accuracy for 1-bit data converters in all-digital millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) basestations. Our algorithms include…
We investigate design and performance of communications over the bandlimited Gaussian channel with one-bit output quantization. A transceiver structure is proposed, which generates the channel input using a finite set of time-limited and…
We consider wireless communication systems with compact planar arrays having densely spaced antenna elements in conjunction with one-bit analog-to-digital and digital-to-analog converters (ADCs/DACs). We provide closed-form expressions for…
A waveform channel is considered where the transmitted signal is corrupted by Wiener phase noise and additive white Gaussian noise (AWGN). A discrete-time channel model is introduced that is based on a multi-sample receiver. Tight lower…