Related papers: Joint Bit Allocation and Hybrid Beamforming Optimi…
Millimeter wave (mmWave) communications have been considered as a key technology for next generation cellular systems and Wi-Fi networks because of its advances in providing orders-of-magnitude wider bandwidth than current wireless…
Enabling communications in the (sub-)THz band will call for massive multiple-input multiple-output (MIMO) arrays at either the transmit- or receive-side, or at both. To scale down the complexity and power consumption when operating across…
Multiple antenna systems have been extensively used by standards designing multi-gigabit communication systems operating in bandwidth of several GHz. In this paper, we study the use of transmitter (Tx) beamforming techniques to improve the…
We present an evolution of multiple-input multiple-output (MIMO) wireless communications known as the tri-hybrid MIMO architecture. In this framework, the traditional operations of linear precoding at the transmitter are distributed across…
A potential tremendous spectrum resource makes millimeter wave (mmWave) communications a promising technology. High power consumption due to a large number of antennas and analog-to-digital converters (ADCs) for beamforming to overcome the…
In this work, we consider the design of hybrid analog-digital (HAD) multi-carrier MIMO-OFDM two-way relaying systems, where the relay station is equipped with a HAD amplify-and-forward architecture and every mobile station is equipped with…
Digital beamforming and waveform generation techniques in MIMO radar offer enormous advantages in terms of flexibility and performance compared to conventional radar systems based on analog implementations. To allow for such fully digital…
A variety of hybrid analog-digital beamforming architectures have recently been proposed for massive multiple-input multiple-output (MIMO) systems to reduce energy consumption and the cost of implementation. In the analog processing network…
Hybrid analog/digital architectures and receivers with low-resolution analog-to-digital converters (ADCs) are two low power solutions for wireless systems with large antenna arrays. Most prior work represents two extreme cases in which…
In this letter, we consider hybrid beamforming for millimeter wave (mmWave) MIMO integrated sensing and communications (ISAC). We design the transmit beam of a dual-functional radar-communication (DFRC) base station (BS), aiming at…
In this paper, we derive an optimal ADC bit-allocation (BA) condition for a Single-User (SU) Millimeter wave (mmWave) Massive Multiple-Input Multiple-Output (Ma-MIMO) receiver equipped with variable-resolution ADCs under power constraint…
High power consumption and expensive hardware are two bottlenecks for practical massive multiple-input multiple-output (mMIMO) systems. One promising solution is to employ low-resolution analog-to-digital converters (ADCs) and…
In this paper, we consider the problem of joint transceiver design for millimeter wave (mmWave)/Terahertz (THz) multi-user MIMO integrated sensing and communication (ISAC) systems. Such a problem is formulated into a nonconvex optimization…
In this paper, we propose a novel joint hybrid precoder and combiner design for maximizing the average achievable sum-rate of single-user orthogonal frequency division multiplexing millimeter wave massive MIMO systems. We formulate the…
In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
In this paper, we investigate the hybrid beamforming design for a multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system, where a multi-antenna base station (BS) with hybrid analog-digital transmit antenna…
We investigate massive multiple-input-multiple output (MIMO) uplink systems with 1-bit analog-to-digital converters (ADCs) on each receiver antenna. Receivers that rely on 1-bit ADC do not need energy-consuming interfaces such as automatic…
Millimeter wave (mmWave) spectrum has drawn attention due to its tremendous available bandwidth. The high propagation losses in the mmWave bands necessitate beamforming with a large number of antennas. Traditionally each antenna is paired…
Network-assisted full-duplex (NAFD) distributed massive multiple input multiple output (M-MIMO) enables the in-band full-duplex with existing half-duplex devices at the network level, which exceptionally improves spectral efficiency. This…