Related papers: Research into the sampling methods of digital beam…
We report the design, operation and performance of a high-resolution, low-latency, bunch-by-bunch feedback system for nano-beam stabilisation. The system employs novel, ultra-low quality-factor cavity beam position monitors (BPMs), a…
A system for online measurement of the transverse beam emittance was developed. It is named $^{4}$PrOB$\varepsilon$aM (4-Profiler Online Beam Emittance Measurement) and was conceived to measure the emittance in a fast and efficient way…
The measurement of beam emittances by extracting the quadrupole mode signal from a 4 plate beam position monitor (BPM) was published at least 40 years ago. Unfortunately, in practice, this method suffers from poor signal to noise ratio and…
Beamline alignment is challenging as the beamline components must be set up ideally so that the rays follow the desired optical path. Automated methods using a digital twin allow for faster diagnostics and improved beam properties compared…
In Spectrally Efficient Frequency Division Multiplexing systems the input data stream is divided into several adjacent subchannels where the distance of the subchannels is less than that of Orthogonal Frequency Division…
In order to achieve its ambitious luminosity target, the SuperKEKB collider must achieve and sustain high beam currents on the order of Ampere in its storage rings. This requires continuous top-up injection and operation with a two-bunch…
The CMS Beam Conditions and Radiation Monitoring System, BRM, will support beam tuning, protect the CMS detector from adverse beam conditions, and measure the accumulated dose close to or inside all sub-detectors. It is composed of…
In order to double the positron injection rate into the KEKB ring, a two-bunch acceleration scheme has been studied at the linac, in which bunches separated by 96 ns are accelerated in 50 Hz. In this scheme the stabilization of energy and…
Affine frequency division multiplexing (AFDM) has recently emerged as a promising waveform for doubly-selective channles [1],[2], owing to its ability to fully exploit time-frequency diversity through appropriate tuning of the chirp-rate…
Electromagnetic modeling with MAFIA of the combined beam position-phase monitors (BPPMs) for the Spallation Neutron Source (SNS) linac has been performed. Time-domain 3-D simulations are used to compute the signal amplitudes and phases on…
The Accelerator Test Facility 2 (ATF2) is a scaled demonstrator system for final focus beam lines of linear high energy colliders. This paper describes the high resolution cavity beam position monitor (BPM) system, which is a part of the…
Fourier ptychographic microscopy (FPM) is a recently proposed quantitative phase imaging technique with high resolution and wide field-of-view (FOV). In current FPM imaging platforms, systematic error sources come from the aberrations, LED…
A new Digital Pulse Processing (DPP) module has been developed, based on a domino ring sampler version 4 chip (DRS4), with good time resolution for LaBr3 detectors, and different digital timing analysis methods for processing the raw…
In order to pursue high-precision beam position measurements for the free-electron laser (FEL) facilities, cavity beam position monitor (CBPM) is employed to measure the transverse position which can meet the requirement of position…
Several heuristic procedures to estimate the rotor position of permanent magnet synchronous motors (PMSM) via signal injection have been reported in the literature. Using averaging theory, a framework to analyse such schemes has been…
Efficient beam alignment is a crucial component in millimeter wave systems with analog beamforming, especially in fast-changing vehicular settings. This paper proposes a position-aided approach where the vehicle's position (e.g., available…
The burgeoning interest within the space community in digital beamforming is largely attributable to the superior flexibility that satellites with active antenna systems offer for a wide range of applications, notably in communication…
In urban areas, the quality of global navigation satellite system (GNSS) signals deteriorates, leading to reduced positioning accuracy. To address this issue, 3D-mapping-aided (3DMA) techniques, such as shadow matching and zonotope shadow…
Most methods for Bundle Adjustment (BA) in computer vision are either centralized or operate incrementally. This leads to poor scaling and affects the quality of solution as the number of images grows in large scale structure from motion…
The dual-functional radar-communication (DFRC) system is an attractive technique, since it can support both wireless communications and radar by a unified hardware platform with real-time cooperation. Considering the appealing feature of…