Related papers: Coherently Assisted Wireless Power Transfer Throug…
User cooperation is an effective technique to tackle the severe near-far user unfairness problem in wireless powered communication networks (WPCNs). In this paper, we consider a WPCN where two collaborating wireless devices (WDs) first…
By reconfiguring the propagation environment of electromagnetic waves artificially, reconfigurable intelligent surfaces (RISs) have been regarded as a promising and revolutionary hardware technology to improve the energy and spectrum…
Wireless charging is a technology of transmitting power through an air gap to electrical devices for the purpose of energy replenishment. The recent progress in wireless charging techniques and development of commercial products have…
This letter introduces a novel pinching-antenna-system (PASS) assisted simultaneous wireless information and power transfer (SWIPT), where multiple pinching antennas (PAs) are strategically activiated on a waveguide to facilitate…
This work compares different linear and nonlinear RF energy harvesting models, including limited or unlimited sensitivity, for simultaneous wireless information and power transfer (SWIPT). The probability of successful SWIPT reception under…
Reliable energy supply remains a crucial challenge in the Internet of Things (IoT). Although relying on batteries is cost-effective for a few devices, it is neither a scalable nor a sustainable charging solution as the network grows…
We study a multi-source wireless power transfer (WPT) enabled network supporting multi-sensor transmissions. Activated by energy harvesting (EH) from multiple WPT sources, sensors transmit short packets to a destination with finite…
This paper studies a general multi-user wireless powered interference channel (IFC) under the harvest-then-transmit protocol, where the communication in channel coherence time consists of two phases, namely wireless energy transfer (WET)…
Simultaneous transmission of information and power over a point-to-point flat-fading complex Additive White Gaussian Noise (AWGN) channel is studied. In contrast with the literature that relies on an inaccurate linear model of the energy…
Dynamical models of wireless power transfer (WPT) systems are of primary importance for the dynamical behavior studies and controller design. However, the existing dynamical models usually suffer from high orders and complicated forms due…
Radio frequency (RF) wireless energy transfer (WET) is a promising technology for powering the growing ecosystem of Internet of Things (IoT) using power beacons (PBs). Recent research focuses on efficient PB architectures that can support…
Recognising the limitations of various existing channel-estimation schemes for energy beamforming, we propose an energy-preserving indirect feedback-based approach for finding the optimal beamforming vector. Upon elaborating on the key…
Wireless information and energy transfer (WIET) represents an emerging paradigm which employs controllable transmission of radio-frequency signals for the dual purpose of data communication and wireless charging. As such, WIET is widely…
Wirelessly powered communications will entail short packets due to naturally small payloads, low-latency requirements and/or insufficient energy resources to support longer transmissions. In this paper, a wirelessly powered communication…
Wireless power transfer (WPT) has been an active topic of research, with a number of WPT schemes implemented in the near-field (coupling) and far-field (radiation) regimes. Here, we consider a beamed WPT scheme based on a dynamically…
In this paper, we study the waveform and passive beamforming design for intelligent reflecting surface (IRS)-aided wireless power transfer (WPT). Generalized multi-user and low complexity single-user algorithms are derived based on…
Frequent power failures can introduce significant packet losses during communication among energy harvesting batteryless wireless sensors. Nodes should be aware of the energy level of their neighbors to guarantee the success of…
Energy of propagating electromagnetic waves can be fully absorbed in a thin lossy layer, but only in a narrow frequency band, as follows from the causality principle. On the other hand, it appears that there are no fundamental limitations…
In this paper, we consider simultaneous wireless information and power transfer (SWIPT) in multi-relay assisted two-hop relay system, where multiple relay nodes simultaneously assist the transmission from source to destination using the…
Wireless transfer of information is the basis of modern communication. It includes cellular, WiFi, Bluetooth and GPS systems, all of which use electromagnetic radio waves with frequencies ranging from typically 100 MHz to a few GHz.…