Related papers: Voltage regulation in buck--boost coniverters feed…
This paper addresses the problem of regulating the output voltage of a DC-DC buck-boost converter feeding a constant power load,which is a problem of current practical interest. Designing a stabilising controller is theoretically…
This paper addresses stability issues of DC networks with constant power loads (CPL). Common DC networks, such as automotive electrical systems and DC microgrids, typically have a step-up/down converter connected in one side to the main bus…
Study of the buck converter and cascaded system considering the voltage mode controller has been done. First the small signal analysis of a buck dc/dc converter is presented and its mathematical representation has been showed. Then, the…
This paper proposes a nonlinear, adaptive controller to increase the stability margin of a direct-current (DC) small-scale electrical network containing a constant power load, whose value is unknown. Due to their negative incremental…
This paper presents design and control of dual-switch non-inverting buck-boost converter (CBB). This converter is designed to simplify the compatibility of electronic ballast with simple and low cost LED drivers. The converter provides…
As a typical switching power supply, the DC-DC converter has been widely applied in DC microgrid. Due to the variation of renewable energy generation, research and design of DC-DC converter control algorithm with outstanding dynamic…
The paper considers a DC-DC buck power converter employing pulse width modulation and voltage feedback control. Global asymptotical stability of a periodical operating mode is examined. It is shown that the stability analysis can be reduced…
In this article, we propose a nonlinear voltage control to ensure power exchange in a multiport interconnected system, which consists of a bidirectional DC-DC converter and generating-storing devices. The converter topology under…
In this paper we consider the problem of voltage regulation of a proton exchange membrane fuel cell connected to an uncertain load through a boost converter. We show that, in spite of the inherent nonlinearities in the current-voltage…
This paper addresses the problem of output voltage regulation for multiple DC-DC converters connected to a grid, and prescribes a robust scheme for sharing power among different sources. Also it develops a method for sharing 120 Hz ripple…
This study presents the modeling, control design, and performance analysis of a DC-DC buck converter using state-space averaging techniques. Buck converters are essential in modern power electronics for regulating DC voltages in renewable…
In this work, the problem of switching control design for DC-DC boost converter is considered, in the case of operation under uncertain equilibrium condition arising due to perturbations in the input and load parameters. Assuming that these…
This paper presents a novel approach to robust load disturbance rejection in DC-DC Buck converters. We propose a novel control scheme based on the design of two nested feedback loops. First, we design the controller in the outer loop using…
This paper presents comparative performance between Analog and digital controller on DC/DC buck-boost converter four switch. The design of power electronic converter circuit with the use of closed loop scheme needs modeling and then…
DC microgrids are becoming popular as effective means to integrate various renewable energy resources. Constant power loads (CPLs) may yield instability due to the negative impedance characteristic. This paper analyzes the stability of the…
It is well-known that measuring the input voltage and current, as the feedforward and feedback terms, are vital for the controller design in the problem of power factor compensation of an AC-DC boost converter. Traditional adaptive…
In recent years the need for DC distribution buses has increased considerably. As it can be noticed in the transport for example the distribution systems of the more electric aircrafts, ships, or electric cars. Given the complexities of the…
A critical challenge in power conversion in electric vehicles is the efficient use of DC-DC buck converters that need to provide 12-V supply for load systems from 400/800-V batteries. This paper presents a literature review on the…
ZIP loads (the parallel combination of constant impedance loads, constant current loads and constant power loads) exist widely in power system. In order to stabilize buck converter based DC distributed system with ZIP load, an adaptive…
DC grids are prone to small-signal instabilities due to the presence of tightly controlled loads trying to keep the power consumption constant over range of terminal voltage variations. Th, so-called, constant power load (CPL) represents a…