Related papers: Performance Analysis of IEEE 802.11ad MAC Protocol

The recently ratified IEEE 802.11e standard defines the Enhanced Distributed Channel Access (EDCA) function for Quality-of-Service (QoS) provisioning in the Wireless Local Area Networks (WLANs). The EDCA uses Carrier Sense Multiple Access…

Autonomous vehicles can construct a more accurate perception of their surrounding environment by exchanging rich sensor data with nearby vehicles. Such exchange can require larger bandwidths than currently provided by ITS-G5/DSRC and…

We propose a linear model of the throughput of the IEEE 802.11 Distributed Coordination Function (DCF) protocol at the data link layer in non-saturated traffic conditions. We show that the throughput is a linear function of the packet…

The IEEE 802.16 technology (WiMAX) is a promising technology for providing last-mile connectivity by radio link due to its high speed data rates, low cost of deployment, and large coverage area. However, the maximum number of channels…

Wireless communications at the chip scale emerge as a interesting complement to traditional wire-based approaches thanks to their low latency, inherent broadcast nature, and capacity to bypass pin constraints. However, as current trends…

IEEE 802.11 and IEEE 802.15.3 are wireless standards originally designed for wireless local area network (WLAN) and wireless personal area network (WPAN). This paper studies MAC throughput analysis of both standards. We present a…

In this paper, we propose a hybrid medium access control protocol (H-MAC) for wireless sensor networks. It is based on the IEEE 802.11's power saving mechanism (PSM) and slotted aloha, and utilizes multiple slots dynamically to improve…

We design a cross-layer approach to optimize the joint use of multi-packet reception and network coding, in order to relieve congestion. We construct a model for the behavior of the 802.11 MAC and apply it to several key canonical topology…

The recently released IEEE 802.15.6 standard specifies several physical (PHY) layer and medium access control (MAC) layer protocols for variety of medical and non-medical applications of Wireless Body Area Networks (WBAN). The most suitable…

Distributed medium access control (MAC) protocols are essential for the proliferation of low cost, decentralized wireless local area networks (WLANs). Most MAC protocols are designed with the presumption that nodes comply with prescribed…

With the increasing popularity of wireless networks, wireless local area networks (WLANs) have attracted significant research interest, which play a critical role in providing anywhere and anytime connectivity. For WLANs the IEEE 802.11…

Millimeter-wave (mmWave) with large spectrum available is considered as the most promising frequency band for future wireless communications. The IEEE 802.11ad and IEEE 802.11ay operating on 60 GHz mmWave are the two most expected wireless…

The end-to-end throughput of multi-hop communication in wireless ad hoc networks is affected by the conflict between forwarding nodes. It has been shown that sending more packets than maximum achievable end-to-end throughput not only fails…

In September 2020, the Broadband Forum published a new industry standard for measuring network quality. The standard centers on the notion of quality attenuation. Quality attenuation is a measure of the distribution of latency and packet…

The inefficiency of the fundamental access method of the IEEEE 802.11 standard is a well-known problem in scenarios where multiple long range and faulty links compete for the shared medium. The alternatives found in the literature are…

Rapid beam alignment is required to support high gain millimeter wave (mmW) communication links between a base station (BS) and mobile users (MU). The standard IEEE 802.11ad protocol enables beam alignment at the BS and MU through a lengthy…

Performance improvement has been among the foci of all previous amendments of IEEE 802.11 protocol. In addition, the draft high efficiency (HE) amendment IEEE 802.11ax, proposed by TGax, aims at increasing network performance. One of the…

Focusing on the increasing market of the sensors and actuators networks, the IEEE 802.11ah Task Group is currently working on the standardization of a new amendment. This new amendment will operate at the sub-1GHz band, ensure transmission…

Extensive energy is consumed by Transceiver communication operation [1]. Existing research on MAC layer focuses to maximize battery-powered sensor node's life. Bottleneck of MAC layer protocol design for WBAN is to achieve high reliability…

Nowadays, millimeter-wave communication centered at the 60 GHz radio frequency band is increasingly the preferred technology for near-field communication since it provides transmission bandwidth that is several GHz wide. The IEEE 802.11ad…