Related papers: High resolution digitization system for the CROSS …

In this paper, we propose an architecture for FPGA emulation of mixed-signal systems that achieves high accuracy at a high throughput. We represent the analog output of a block as a superposition of step responses to changes in its analog…

The discrete cosine transform (DCT) is the key step in many image and video coding standards. The 8-point DCT is an important special case, possessing several low-complexity approximations widely investigated. However, 16-point DCT…

In this work, a serial on-line cluster reconstruction technique based on FPGA technology was developed to compress experiment data and reduce the dead time of data transmission and storage. At the same time, X-ray imaging experiment based…

We developed a compact and easy-to-use phase meter based on a zero-crossing counting algorithm for digitized signals. Owing to the algorithm, the phase meter has low-noise and wide dynamic range. Low-noise differential phase measurements…

Non-contact scanning probe microscopy (SPM) has developed into a powerful technique to image many different properties of samples. The conventional method involves monitoring the amplitude, phase or frequency of a cantilever oscillating at…

The Data Acquisition System of the LZ experiment, the 10-tonne dark matter detector to be installed at the Sanford Underground Research Facility (SURF), will collect signals from 788 photomultiplier tubes (PMTs). Because the signals from…

In this paper, an on-chip photonic sampled and quantized analog-to-digital converter (ADC) on thin-film lithium niobate platform is experimentally demonstrated. Using two phase modulators as a sampler and a 5$\times$5 multimode interference…

The ATLAS experiment at CERN measures energy of proton-proton (p-p) collisions with a repetition frequency of 40 MHz at the Large Hadron Collider (LHC). The readout electronics of liquid-argon (LAr) calorimeters are being prepared for high…

We describe a digital microwave platform called Presto, designed for measurement and control of multiple quantum bits (qubits) and based on the third-generation radio-frequency system on a chip. Presto uses direct digital synthesis to…

We introduce a prototype FPGA decoder implementing the recently discovered Relay-BP algorithm and targeting memory experiments on the $[[144,12,12]]$ bivariate bicycle quantum low-density parity check code. The decoder is both fast and…

Time to Digital Converters (TDCs) are very common devices in particles physics experiments. A lot of "off-the-shelf" TDCs can be employed but the necessity of a custom DAta acQuisition (DAQ) system makes the TDCs implemented on the…

This paper studies computationally efficient methods and their minimax optimality for high-dimensional clustering and signal recovery under block signal structures. We propose two sets of methods, cross-block feature aggregation PCA…

The readout electronics upgrade for the ATLAS Liquid Argon Calorimeters at the CERN Large Hadron Collider requires a radiation-hard ADC. The design of a radiation-hard dual-channel 12-bit 40 MS/s pipeline ADC for this use is presented. The…

High-throughput imaging workflows, such as Parallel Rapid Imaging with Spectroscopic Mapping (PRISM), generate data at rates that exceed conventional real-time processing capabilities. We present a scalable FPGA-based preprocessing pipeline…

We present an overview of the 'ICE' hardware and software framework that implements large arrays of interconnected FPGA-based data acquisition, signal processing and networking nodes economically. The system was conceived for application to…

Maintaining the required performance of the CMS electromagnetic calorimeter (ECAL) barrel at the High-Luminosity Large Hadron Collider (HL-LHC) requires the replacement of the entire on-detector electronics. 12240 new very front end (VFE)…

In this work we demonstrate an FPGA-based coherent optical frequency domain reflectometry setup for cable monitoring. Using coherent detection for averaging and narrowband filtering, we significantly improve the signal-to-noise ratio (SNR)…

Global 21cm experiments aim to measure the sky averaged HI absorption signal from cosmic dawn and the epoch of reionisation. However, antenna chromaticity coupling to bright foregrounds can introduce distortions into the observational data…

Analog-to-digital converters (ADCs) allow physical signals to be processed using digital hardware. Their conversion consists of two stages: Sampling, which maps a continuous-time signal into discrete-time, and quantization, i.e.,…

We present the development and characterization of a generic, reconfigurable, low-cost ($<$ 350 USD) software-defined digital receiver system (DRS) for temporal correlation measurements in atomic spin ensembles. We demonstrate the use of…