Related papers: Comparative Analysis of Conventional and Modified …
Conventional boost converters are essential to connect low-voltage energy source such as battery with high voltage DC bus in Electric Vehicles due to its simple construction and high conversion efficiency. However, large output capacitor…
We present here the concept of three-arm current comparator impedance bridge, which allows comparisons among three unlike impedances. Its purpose is the calibration of impedances having arbitrary phase angles, against calibrated nearly-pure…
Voltage Source Converters (VSC) are becoming more common in modern High Voltage DC (HVDC) transmission systems. One of the major challenges in a multi-terminal VSCHVDC is protection against DC side faults. Two major designs, namely, the…
Based on the reduced density matrix method, we compare two different approaches to calculate the dynamics of the electron transfer in systems with donor, bridge, and acceptor. In the first approach a vibrational substructure is taken into…
The transition to electric transportation demands efficient and cost-effective powertrains. Optimizing energy use is crucial for extending range and reducing expenses. However, comparing inverter and motor efficiency based on inverter…
This paper presents a simulation and experimental validation of H-bridge inverter with the implementation of a Newton-Raphson algorithm for selective harmonics elimination. Contributions are made in interfacing and programming of Arduino…
This paper proposes a new DC-AC converter with a less number of semiconductor switches and therefore gate drive and control circuit components. A salient feature of this inverter is its pure sinusoidal line-to-line voltages with no need for…
Having sufficient grid-forming sources is one of the necessary conditions to guarantee the stability in a power system hosting a very large share of inverter-based generation. The grid-forming function has been historically fulfilled by…
An algorithm for simulation of switching converters is proposed in the paper. The algorithm is based on simulation of averaged circuit model applying "switching cell" concept, and construction of instantaneous values of the waveforms using…
The dual active bridge (DAB) converter has been popular in many applications for its outstanding power density and bidirectional power transfer capacity. Up to now, triple phase shift (TPS) can be considered as one of the most advanced…
In Part I of this paper a method for the Harmonic Stability Assessment (HSA) of power systems with a high share of Converter-Interfaced Distributed Energy Resources (CIDERs) was proposed. Specifically, the Harmonic State-Space (HSS) model…
The renewable energy proliferation calls upon the grid operators and planners to systematically evaluate the potential impacts of distributed energy resources (DERs). Considering the significant differences between various inverter-based…
This paper presents the development of a mathematical model of a converter state space model for a hybrid microgrid. The hybrid model combines the models of components such as DC-Converters, DC-AC converters, and their individual…
The influx of non-linear power electronic loads into the distribution network has the potential to disrupt the existing distribution transformer operations. They were not designed to mediate the excessive heating losses generated from the…
This article is the second part of a paper series about interference in extremum (i.e., peak or valley) current-mode control, which applies to both fixed and variable switching frequency power converters. Specifically, this part presents…
Fault detection and reconfiguration in fault-tolerant converters may complicated and necessitate using all-purpose microprocessors and high-speed sensors to guarantee the satisfactory performance of power converters. Therefore, providing…
There is a trade-off between transient performance and line current distortion of the DC bus voltage control of single-phase grid-connected voltage source converters. This paper presents an improved DC bus voltage control scheme of such…
Constant-power loads are notoriously known to destabilise power systems, such as DC microgrids, due to their negative incremental impedance. This paper equips distributed generation units with decentralised L1 adaptive controllers at the…
A simple design recipe for deep Transformers is to compose identical building blocks. But standard transformer blocks are far from simple, interweaving attention and MLP sub-blocks with skip connections & normalisation layers in precise…
The power flow control of multi-active bridge converters requires a comprehensive steady-state analysis of the converter and the determination of conditions for zero voltage switching of all switching in the converter which result in…