Related papers: Channel Estimation for MIMO Hybrid Architectures w…
Hybrid analog/digital precoding in millimeter-wave (mmWave) multi-input multi-ouput (MIMO) systems is capable of achieving the near-optimal full-digital performance at reduced hardware cost and power consumption compared to its full-RF…
We present a novel iterative detection and decoding scheme for the uplink of large-scale multiuser multiple-antenna systems. In order to reduce the receiver's energy consumption and computational complexity, 1-bit analog-to-digital…
The power consumption of high-speed, high-resolution analog to digital converters (ADCs) is a limiting factor in implementing large-bandwidth mm-wave communication systems. A mitigating solution, which has drawn considerable recent…
Millimeter-wave (mmWave) communication operated in frequency bands between 30 and 300 GHz has attracted extensive attention due to the potential ability of offering orders of magnitude greater bandwidths combined with further gains via…
Millimeter wave systems suffer from high power consumption and are constrained to use low resolution quantizers --digital to analog and analog to digital converters (DACs and ADCs). However, low resolution quantization leads to reduced data…
In this paper, we aim to design highly energy efficient end-to-end communication for millimeter wave multiple-input multiple-output systems. This is done by jointly optimizing the digital-to-analog converter (DAC)/analog-to-digital…
Hybrid beamforming is key to achieving energy-efficient 5G wireless networks equipped with massive amount of antennas. Low-resolution data converters bring yet another degree of freedom to energy efficiency for the state-of-the-art 5G…
Low-resolution analog-to-digital converters (ADCs) simplify the design of millimeter-wave (mmWave) massive multi-user multiple-input multiple-output (MU-MIMO) basestations, but increase vulnerability to jamming attacks. As a remedy, we…
The recently introduced atomic norm minimization (ANM) framework for parameter estimation is a promising candidate towards low overhead channel estimation in wireless communications. However, previous works on ANM-based channel estimation…
This paper is concerned with channel estimation in MIMO systems with few-bit ADCs. In these systems, a linear minimum mean-squared error (MMSE) channel estimator obtained in closed-form is not an optimal solution. We first consider a deep…
The performance of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems is limited by the sparse nature of propagation channels and the restricted number of radio frequency (RF) chains at transceivers. The introduction of…
This paper proposes a correlation-based three-stage channel estimation strategy with low pilot overhead for reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) multi-user (MU) MIMO systems, in which both users and base…
In this work, we study the achievable rate and the energy efficiency of Analog, Hybrid and Digital Combining (AC, HC and DC) for millimeter wave (mmW) receivers. We take into account the power consumption of all receiver components, not…
To perform multi-user multiple-input and multiple-output transmission in millimeter-wave(mmWave) cellular systems, the high-dimensional channels need to be estimated for designing the multi-user precoder. Conventional grid-based compressed…
Hybrid digital/analog architecture and low-resolution analog-to-digital/digital-to-analog converters (ADCs /DACs) are two low-cost implementations for large-scale millimeter wave (mmWave) systems. In this paper, we investigate the problem…
Massive multiple-input multiple-output (MIMO) is expected to play a central role in future wireless systems. The deployment of large antenna arrays at the base station and the mobile users offers multiplexing and beamforming gains that…
In this paper, we propose an oversampling based low-resolution aware least squares channel estimator for large-scale multiple-antenna systems with 1-bit analog-to-digital converters on each receive antenna. To mitigate the information loss…
In this paper, we propose a new hybrid analog and digital combining architecture for millimeter wave (mmWave) multi-user multiple-input multiple-output (MU-MIMO) systems. The proposed structure employs antenna subset selection per radio…
Extremely low-resolution (e.g. one-bit) analog-to-digital converters (ADCs) and digital-to-analog converters (DACs) can substantially reduce hardware cost and power consumption for MIMO radar especially with large scale antennas. In this…
Recently, a switch-based hybrid massive MIMO structure that aims to reduce the hardware complexity and power consumption has been proposed as a potential candidate for millimeter wave (mmWave) communications. Exploiting the sparse nature of…