Related papers: Hybrid Precoding for Multi-Group Multicasting in m…
Hybrid precoding is a cost-effective approach to support directional transmissions for millimeter wave (mm-wave) communications, and its design challenge mainly lies in the analog component which consists of a network of phase shifters. The…
This letter investigates the hybrid analog and digital beamforming (HBF) design for multiuser millimeter wave (mmWave) communication systems based on the minimum mean square error (MMSE) criterion. Using the alternating minimization method,…
This paper deals with the problem of precoding in multibeam satellite systems. In contrast to general multiuser multiple-input-multiple-output (MIMO) cellular schemes, multibeam satellite architectures suffer from different challenges.…
The focus of this paper is on multi-user MIMO transmissions for millimeter wave systems with a hybrid precoding architecture at the base-station. To enable multi-user transmissions, the base-station uses a cell-specific codebook of…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
To alleviate the high cost of hardware in mmWave systems, hybrid analog/digital precoding is typically employed. In the conventional two-stage feedback scheme, the analog beamformer is determined by beam search and feedback to maximize the…
In millimeter wave (mmWave) communication systems, existing hybrid beamforming solutions generally require a large number of high-resolution phase shifters (PSs) to realize analog beamformers, which still suffer from high hardware…
This paper investigates the problem of hybrid precoder and combiner design for multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems operating in millimeter-wave (mmWave) bands. We propose a novel…
The potential of deploying large-scale antenna arrays in future wireless systems has stimulated extensive research on hybrid transceiver designs aiming to approximate the optimal fully-digital schemes with much reduced hardware cost and…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
Millimeter wave (mmWave) is a practical solution to provide high data rate for the vehicle-to-everything (V2X) communications. This enables the future autonomous vehicles to exchange big data with the base stations (BSs) such as the…
In this paper, we focus on the phenomenon of beam misalignment in Millimeter-wave (mmWave) multi-receiver communication systems, and propose robust hybrid precoding designs that alleviate the performance loss caused by this effect. We…
Recently, full duplex (FD) has been studied in 5G LTE millimeter wave (mmWave) cellular communications for New Radio in 3GPP releases 15-17. FD allows bidirectional transmission over the same resources and has the potential to reduce…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
Hybrid analog-digital (A/D) transceivers designed for millimeter wave (mmWave) systems have received substantial research attention, as a benefit of their lower cost and modest energy consumption compared to their fully-digital…
In millimeter wave (mmWave) systems, antenna architecture limitations make it difficult to apply conventional fully digital precoding techniques but call for low cost analog radio-frequency (RF) and digital baseband hybrid precoding…
The deployment of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems cannot rely solely on digital precoding due to hardware constraints. Instead, hybrid precoding, which combines digital and radio frequency (RF)…
To enable user diversity and multiplexing gains, a fully digital precoding multiple input multiple output (MIMO) architecture is typically applied. However, a large number of radio frequency (RF) chains make the system unrealistic to…
Hybrid precoder and combiner designs are conceived for decentralized parameter estimation in millimeter wave (mmWave) multiple-input multiple-output (MIMO) wireless sensor networks (WSNs). More explicitly, efficient pre- and post-processing…
Hybrid beamforming is a promising technique to reduce the complexity and cost of massive multiple-input multiple-output (MIMO) systems while providing high data rate. However, the hybrid precoder design is a challenging task requiring…