Related papers: Shear Destruction of Frictional Aging and Memory
Solid friction between two rough surfaces is often observed to increase logarithmically over time due to contact creeping. An intriguing question is whether a similar aging effect occurs in contact line (CL) friction over rough substrates.…
We review the present state of understanding of solid friction at low velocities and for systems with negligibly small wear effects. We first analyze in detail the behavior of friction at interfaces between wacroscopic hard rough solids,…
Particles suspended in a Newtonian fluid raise the viscosity and also generally give rise to a shear-rate dependent rheology. In particular, pronounced shear thickening may be observed at large solid volume fractions. In a recent article…
The mechanical response of a wet granular layer to imposed shear is studied experimentally at low applied normal stress. The granular material is immersed in water and the shear is applied by sliding a plate resting on the upper surface of…
We consider two perfectly smooth featureless surfaces at T=0, defined only by their respective dielectric functions, separated by a finite distance, and ask the question whether they can experience any friction when sheared parallel to…
We find that in simulations of quasi-statically sheared frictional disks, the shear jamming transition can be characterized by an abrupt jump in the number of force bearing contacts between particles. This mechanical coordination number…
We study the response to shear of a one-dimensional monolayer embedded between two rigid plates, where the upper one is externally driven. The shear is shown to excite ``shearons'', which are collective modes of the embedded system with…
Many properties of soft contact interfaces are controlled by the contact area (e.g. friction, contact stiffness and surface charge generation). The contact area increases with the contact age at rest. In contrast, it usually reduces under…
Contacts between particles in dense, sheared suspensions are believed to underpin much of their rheology. Roughness and adhesion are known to constrain the relative motion of particles, and thus globally affect the shear response, but an…
Analytical and numerical modelling of the nonlinear interaction of shear wave with a frictional interface is presented. The system studied is composed of two homogeneous and isotropic elastic solids, brought into frictional contact by…
Shear thickening of particle suspensions is characterized by a transition between lubricated and frictional contacts between the particles. Using 3D numerical simulations, we study how the inter-particle friction coefficient influences the…
Several mechanisms cause a granular material to strengthen over time at low applied stress. The strength is determined from the maximum frictional force F_max experienced by a shearing plate in contact with wet or dry granular material…
Solids are distinguished from fluids by their ability to resist shear. In traditional solids, the resistance to shear is associated with the emergence of broken translational symmetry as exhibited by a non-uniform density pattern, which…
We report on memory effects involved in the transient frictional response of a contact interface between a silicone rubber and a spherical glass probe when it is perturbed by changes in the orientation of the driving motion or by velocity…
Particle-based simulations of discontinuous shear thickening (DST) and shear jamming (SJ) suspensions are used to study the role of stress-activated constraints, with an emphasis on resistance to gear-like rolling. Rolling friction…
We perform physical and numerical experiments to study the stick-slip response of a stack of slabs in contact through dry frictional interfaces driven in quasistatic shear. The ratio between the drive's stiffness and the slab's shear…
Jammed states of frictional granular systems can be induced by shear strain at densities below the isostatic jamming density ($\phi_c$). It remains unclear, however, how much friction affects this so-called shear-jamming. Friction appears…
The temperature increase in the contact regions between solids in sliding contact has a huge influence on friction and wear. Here we test an analytical theory for the flash temperature, valid for randomly rough surface with multiscale…
The classical Hertzian contact model establishes a monotonic correlation between contact force and area. Here, we showed that the interplay between local friction and structural instability can deliberately lead to unconventional contact…
True contact between randomly rough solids consists of myriad individual micro-junctions. While their total area controls the adhesive friction force of the interface, other macroscopic features, including viscoelastic friction, wear,…