Related papers: Gate Leakage Suppression and Breakdown Voltage Enh…

We present a novel p-GaN gate HEMT structure with reduced hole concentration near the Schottky interface by doping engineering in MOCVD, which aims at lowering the electric field across the gate. By employing an additional unintentionally…

We report a dramatic current reduction, or a resistance increase, by a few orders of magnitude of two common-anode Au/Ti/pGaN Schottky junctions annealed within a certain annealing condition window (600 - 700 oC, 1 - 4 min). Results from…

Because high electron mobility transistors (HEMTs) often exhibit significant gate leakage during high-temperature operation, the choice of Schottky metal is critical. Increased gate leakage and reduced ON/OFF ratio are unsuitable for the…

In this work, AlGaN/GaN HEMTs with dual-layer SiNx stressors (composed of a low-stress layer and a high-stress layer) were investigated. The low-stress padding layer solved the surface damage problem caused during the deposition of the…

The absence of a band-gap in graphene limits the gate modulation of its electron conductivity, both in regular graphene as well as in PN junctions, where electrostatic barriers prove transparent to Klein tunneling. We demonstrate a novel…

In this work, the threshold voltage instability of normally-off p-GaN high electron mobility transistors (HEMTs) has been investigated by monitoring the gate current density during device on-state. The origin of the gate current variations…

We present an extensive analysis of the trapping processes induced by drain bias stress in AlGaN/GaN high-electron-mobility transistors (HEMTs) with p-GaN gate. We demonstrate that: (i) with increasing drain stress, pulsed I-V and VTH…

In this work, we studied the gate breakdown mechanisms of p-GaN gate AlGaN/GaN HEMTs by a novel multiple-gate-sweep-based method. For the first time, three different breakdown mechanisms were observed and identified separately in the same…

Graphene interfaced with a semiconductor forms a Schottky junction with rectifying properties, however, fluctuations in the Schottky barrier height are often observed. In this work, Schottky junctions are fabricated by transferring chemical…

In this letter, we report on a unique device design strategy for increasing the breakdown voltage and hence Baliga Figure of Merit (BFOM) of III-nitride HEMTs by engineering the gate edge towards the drain. The breakdown of such devices…

Graphene is considered to be a promising candidate for future nano-electronics due to its exceptional electronic properties. Unfortunately, the graphene field-effect-transistors (FETs) cannot be turned off effectively due to the absence of…

We report results of experimental investigation of the low-frequency noise in the top-gate graphene transistors. The back-gate graphene devices were modified via addition of the top gate separated by 20 nm of HfO2 from the single-layer…

The electron-hole symmetry in the structure "graphene - insulating substrate -semiconductor gate" is violated due to an asymmetrical drop of potential in the semiconductor gate under positive or negative biases. The gate voltage…

Graphene based THz modulators are promising due to the conical band structure and high carrier mobility of graphene. Here, we tune the Fermi level of graphene via electrical gating with the help of ionic liquid to control the THz…

A broad TCAD simulation analysis of a monolithic common drain bidirectional GaN HEMT was performed. We used gate-to-gate distances of 4 microns and 6 microns for the devices optimized with two field plates. The breakdown voltages were 675V…

Short-term reliability and robustness of 110 nm AlN/GaN HEMTs has been evaluated by means of off-state, semi-on state and on-state step stress tests on devices having different gate-drain distance, LGD. While breakdown voltages and critical…

High Electron Mobility Transistors (HEMTs) are most suitable for harsh environments as they operate reliably under extreme conditions such as high voltages, high temperatures, radiation exposure and corrosive atmospheres. In this article,…

Graphene is a promising candidate for optoelectronic applications. In this report, a double gated bilayer graphene FET has been made using a combination of electrostatic and electrolytic gating in order to form an abrupt p-n junction. The…

The modulation depth of 2-D electron gas (2DEG) based THz modulators using AlGaAs/GaAs heterostructures with metal gates is inherently limited to < 30%. The metal gate not only attenuates the THz signal (> 90%) but also severely degrades…

By using four layered graphene/gallium nitride (GaN) Schottky diodes with an undoped GaN spacer, we demonstrate highly effective gating of graphene at low bias rendering this type of structure very promising for potential applications. An…