Related papers: PrecoderNet: Hybrid Beamforming for Millimeter Wav…
The hybrid analog/digital architecture that connects a limited number of RF chains to multiple antennas through phase shifters could effectively address the energy consumption issues in massive multiple-input multiple-output (MIMO) systems.…
Recently, the reconfigurable intelligent surface (RIS), benefited from the breakthrough on the fabrication of programmable meta-material, has been speculated as one of the key enabling technologies for the future six generation (6G)…
Hybrid precoding is a cost-efficient technique for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) communications. This paper proposes a deep learning approach by using a distributed neural network for hybrid…
Utilizing Deep Reinforcement Learning (DRL) for Reconfigurable Intelligent Surface (RIS) assisted wireless communication has been extensively researched. However, existing DRL methods either act as a simple optimizer or only solve problems…
The millimeter wave (mmWave) multiuser multiple-input multiple-output (MU-MIMO) systems with discrete lens arrays (DLA) have received great attention due to their simple hardware implementation and excellent performance. In this work, we…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
Millimeter-wave (mmWave) communication systems, particularly those leveraging multi-user multiple-input and multiple-output (MU-MIMO) with hybrid beamforming, face challenges in optimizing user throughput and minimizing latency due to the…
In massive MIMO systems, hybrid beamforming is an essential technique for exploiting the potential array gain without using a dedicated RF chain for each antenna. In this work, we consider the data phase in a massive MIMO communication…
In this paper, we propose an end-to-end deep learning-based joint transceiver design algorithm for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems, which consists of deep neural network (DNN)-aided pilot…
Beamforming enhances signal strength and quality by focusing energy in specific directions. This capability is particularly crucial in cell-free integrated sensing and communication (ISAC) systems, where multiple distributed access points…
This paper presents a distributed beamforming framework for a constellation of airborne platform stations (APSs) in a massive Multiple-Input and Multiple-Output (MIMO) non-terrestrial network (NTN) that targets the downlink sum-rate…
Hybrid precoding plays a key role in realizing massive multiple-input multiple-output (MIMO) transmitters with controllable cost. MIMO precoders are required to frequently adapt based on the variations in the channel conditions. In hybrid…
The high energy consumption of massive multi-input multi-out (MIMO) system has become a prominent problem in the millimeter wave(mm-Wave) communication scenario. The hybrid precoding technology greatly reduces the number of radio…
This paper proposes a deep learning approach to channel sensing and downlink hybrid beamforming for massive multiple-input multiple-output systems operating in the time division duplex mode and employing either single-carrier or…
In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…
In this paper, we propose a beamforming design for dual-functional radar-communication (DFRC) systems at the millimeter wave (mmWave) band, where hybrid beamforming and sub-arrayed MIMO radar techniques are jointly exploited. We assume that…
Hybrid beamforming is key to achieving energy-efficient 5G wireless networks equipped with massive amount of antennas. Low-resolution data converters bring yet another degree of freedom to energy efficiency for the state-of-the-art 5G…
As more and more people choose high-speed rail (HSR) as a means of transportation for short trips, there is ever growing demand of high quality of multimedia services. With its rich spectrum resources, millimeter wave (mm-wave)…
Channel state information (CSI) feedback is necessary for the frequency division duplexing (FDD) multiple input multiple output (MIMO) systems due to the channel non-reciprocity. With the help of deep learning, many works have succeeded in…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…