Related papers: Reset Control for Vibration Disturbance Rejection
Harmonic generation during radio frequency (RF)-dc conversion causes performance degradation of a microwave rectifying circuit. To suppress and recycle the harmonic power, this letter proposes a novel compact dual-band resonator (DBR) based…
This article is the second part of a paper series about interference in extremum (i.e., peak or valley) current-mode control, which applies to both fixed and variable switching frequency power converters. Specifically, this part presents…
The ever-increasing industry desire for improved performance makes linear controller design run into fundamental limitations. Nonlinear control methods such as Reset Control (RC) are needed to overcome these. RC is a promising candidate…
The stability of standing in humans is a complex process that leads to maintaining the upright position against external disturbances. Balance control during standing is of vital importance for humans in daily life. An issue that is still…
As an alternative to both classical PID-type and modern model-based approaches to solving control problems, active disturbance rejection control (ADRC) has gained significant traction in recent years. With its simple tuning method and…
Fundamental sensor feedback limitations for improving rotor angle stability using local frequency or phase angle measurement are derived. Using a two-machine power system model, it is shown that improved damping of inter-area oscillations…
Continuous higher order sliding mode (CHOSM) controllers represent an efficient tool for disturbance rejection. For the systems with relative degree r, CHOSM approaches provide theoretically exact compensation of the matched Lipschitz…
Mechanical vibrations are known to affect frictional sliding and the associated stick-slip patterns causing sometimes a drastic reduction of the friction force. This issue is relevant for applications in nanotribology and to understand…
PID controllers cannot satisfy the high performance requirements since they are restricted by the water-bed effect. Thus, the need for a better alternative to linear PID controllers increases due to the rising demands of the high-tech…
This paper presents an application of adaptive control algorithm in order to reject the external disturbances in dual-stage hard disk drives. For this purpose, a dual PID controller is first designed without the plant exposure to external…
We investigate the combined effect of rectification and nonlinear dynamics on the behavior of several simple nonlinear circuits. We consider the classic Resistor-Inductor-Diode (RLD) circuit driven by a low frequency source when an…
Oscillator phase noise has been shown to be one of the main performance limiting factors in full-duplex systems. In this paper, we consider the problem of self-interference cancellation with phase noise suppression in full-duplex systems.…
Precision motion stages are playing a prominent role in various manufacturing equipment. The drastically increasing demand for higher throughput in integrated circuit (IC) manufacturing and inspection calls for the next-generation precision…
Time--delayed feedback is exploited for controlling noise--induced motion in coherence resonance oscillators. Namely, under the proper choice of time delay, one can either increase or decrease the regularity of motion. It is shown that in…
Given the high dimensionality and underlying complexity of many oscillatory dynamical systems, phase reduction is often an imperative first step in control applications where oscillation timing and entrainment are of interest.…
This paper addresses the main goal of using reset control in precision motion control systems, breaking of the well-known "Waterbed effect". A new architecture for reset elements will be introduced which has a continuous output signal as…
Reconfigurable intelligent surfaces (RIS) have emerged as a transformative technology for electromagnetic (EM) wave manipulation, offering unprecedented control over wave reflections compared to traditional metallic reflectors. By utilizing…
The objective of this research is to mitigate vibrations in induction motors. To achieve this goal, a discontinuous pulse width modulation (PWM) control strategy based on carrier wave modulation is proposed for multilevel inverters. This…
High altitude simulation test benches for aero engines employ multi chamber, multi valve intake systems that demand effective decoupling and strong disturbance rejection during transient tests. This paper proposes a coordinated active…
Impedance control is a well-established technique to control interaction forces in robotics. However, real implementations of impedance control with an inner loop may suffer from several limitations. Although common practice in designing…