Related papers: Beamforming Design in Multiple-Input-Multiple-Outp…
This paper proposes the joint use of digital self-interference cancellation (DSIC) and spatial suppression to mitigate far-field self-interference (SI) in full-duplex multiple-input multiple-output (MIMO) systems. Far-field SI, caused by…
This paper focuses on the fundamental problem of maximizing the achievable weighted sum rate (WSR) at information receivers (IRs) in an intelligent reflecting surface (IRS) assisted simultaneous wireless information and power transfer…
A wireless network serving multiple users in the millimeter-wave or the sub-terahertz band by a base station is considered. High-throughput multi-user hybrid-transmit beamforming is conceived by maximizing the minimum rate of the users. For…
Sparse array design aided by emerging fast sensor switching technologies can lower the overall system overhead by reducing the number of expensive transceiver chains. In this paper, we examine the active sparse array design enabling the…
This paper investigates a reconfigurable intelligent surface (RIS)-aided multi-user multiple-input multiple-output (MIMO) system by considering only the statistical channel state information (CSI) at the base station (BS). We aim to…
This study investigates subarray-level movable antenna (MA) architecture for multi-user MIMO (MU-MIMO) systems. Unlike conventional systems with fixed-position antennas (FPAs), the proposed scheme harnesses the additional positional degrees…
In many wireless communication applications, it is desirable to transmit the same data to multiple user equipments (UEs). Physical layer multicasting presents an efficient transmission topology to exploit the beamforming capabilities at the…
Digital beamforming and waveform generation techniques in MIMO radar offer enormous advantages in terms of flexibility and performance compared to conventional radar systems based on analog implementations. To allow for such fully digital…
Fully digital massive MIMO systems with large numbers (1000+) of antennas offer dramatically increased capacity gains from spatial multiplexing and beamforming. Designing digital receivers that can scale to these array dimensions presents…
This paper investigates robust and secure multiuser multiple-input single-output (MISO) downlink communications assisted by a self-sustainable intelligent reflection surface (IRS), which can simultaneously reflect and harvest energy from…
In magnetic resonant coupling (MRC) enabled multiple-input multiple-output (MIMO) wireless power transfer (WPT) systems, multiple transmitters (TXs) each with one single coil are used to enhance the efficiency of simultaneous power transfer…
In this paper, we study the transmit signal optimization in a multiple-input multiple-output (MIMO) radar system for sensing the angle information of multiple targets via their reflected echo signals. We consider a challenging and practical…
In this paper, a general cognitive radio system consisting of a set of users with different level of spectrum access including two primary transceivers and several types of secondary users is considered. It is assumed that two secondary…
In this paper, the beam squint problem, which causes significant variations in radiated beam gain over frequencies in millimeter wave communication system, is investigated. A constant modulus beamformer design, which is formulated to…
Reconfigurable intelligent surfaces (RISs) have huge potential to improve spectral and energy efficiency in future wireless systems at a minimal cost. However, early prototype results indicate that deploying hundreds or thousands of…
Intelligent reflecting surfaces (IRSs) are envisioned as a low-cost solution to achieve high spectral and energy efficiency in future communication systems due to their ability to customize wireless propagation environments. Although…
This paper investigates a multiuser multiple-input single-output (MISO) full-duplex (FD) system for simultaneous wireless information and power transfer (SWIPT), in which a multi-antenna base station (BS) simultaneously sends wirelessly…
Hybrid beamforming is an emerging technology for massive multiple-input multiple-output (MIMO) systems due to the advantages of lower complexity, cost, and power consumption. Recently, intelligent reflection surface (IRS) has been proposed…
This paper studies the transmit beamforming in a downlink integrated sensing and communication (ISAC) system, where a base station (BS) equipped with a uniform linear array (ULA) sends combined information-bearing and dedicated radar…
Hybrid beamforming for frequency-selective channels is a challenging problem as the phase shifters provide the same phase shift to all of the subcarriers. The existing approaches solely rely on the channel's frequency response and the…