Related papers: Joint Synchronization, Phase Noise and Compressive…
Millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems typically employ hybrid mixed signal processing to avoid expensive hardware and high training overheads. {However, the lack of fully digital beamforming at…
In this letter, we aim to design a robust hybrid precoder and combiner against beam misalignment in millimeter-wave (mmWave) communication systems. We consider the inclusion of the `error statistics' into the precoder and combiner design,…
Hybrid massive MIMO structures with lower hardware complexity and power consumption have been considered as a potential candidate for millimeter wave (mmWave) communications. Channel covariance information can be used for designing…
Millimeter-wave (mmWave) communication operated in frequency bands between 30 and 300 GHz has attracted extensive attention due to the potential ability of offering orders of magnitude greater bandwidths combined with further gains via…
Hybrid analog/digital precoding in millimeter-wave (mmWave) multi-input multi-ouput (MIMO) systems is capable of achieving the near-optimal full-digital performance at reduced hardware cost and power consumption compared to its full-RF…
To perform multi-user multiple-input and multiple-output transmission in millimeter-wave(mmWave) cellular systems, the high-dimensional channels need to be estimated for designing the multi-user precoder. Conventional grid-based compressed…
Asynchronous radio transceivers often lead to significant range and velocity ambiguity, posing challenges for precise positioning and velocity estimation in passive-sensing perceptive mobile networks (PMNs). To address this issue, carrier…
5G mmWave massive MIMO systems are likely to be deployed in dense urban scenarios, where increasing network capacity is the primary objective. A key component in mmWave transceiver design is channel estimation which is challenging due to…
In this paper, the problem of joint oscillator phase noise (PHN) estimation and data detection for multi-input multi-output (MIMO) systems using bit-interleaved coded modulation (BICM) is analyzed. A new MIMO receiver that iterates between…
A potential tremendous spectrum resource makes millimeter wave (mmWave) communications a promising technology. High power consumption due to a large number of antennas and analog-to-digital converters (ADCs) for beamforming to overcome the…
Hybrid analog/digital architectures and receivers with low-resolution analog-to-digital converters (ADCs) are two low power solutions for wireless systems with large antenna arrays. Most prior work represents two extreme cases in which…
The cost of radio frequency (RF) chains is the biggest drawback of massive MIMO millimeter wave networks. By employing spatial modulation (SM), it is possible to implement lower number of RF chains than transmit antennas but still achieve…
In millimeter-wave communications, multiple-input-multiple-output (MIMO) systems use large antenna arrays to achieve high gain and spectral efficiency. These massive MIMO systems employ hybrid beamformers to reduce power consumption…
For millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems, hybrid processing architecture is usually used to reduce the complexity and cost, which poses a very challenging issue in channel estimation. In this paper,…
6G operators may use millimeter wave (mmWave) and sub-terahertz (sub-THz) bands to meet the ever-increasing demand for wireless access. Sub-THz communication comes with many existing challenges of mmWave communication and adds new…
In this paper, the multiple-input multiple-output (MIMO) transmit beampattern matching problem is considered. The problem is formulated to approximate a desired transmit beampattern (i.e., an energy distribution in space and frequency) and…
In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…
This paper develops energy-efficient hybrid beamforming designs for mmWave multi-user systems where analog precoding is realized by switches and phase shifters such that radio frequency (RF) chain to transmit antenna connections can be…
We propose a new scheme for the robust estimation of the millimeter wave (mmWave) channel. Our approach is based on a sparse formulation of the channel estimation problem coupled with a frame theoretic representation of the sensing…
Future multi-input multi-output (MIMO) wireless communications systems will use beamforming as a first-step towards realizing the capacity requirements necessitated by the exponential increase in data demands. The focus of this work is on…