Related papers: Multiscale Poromechanics of Wet Cement Paste
Multiscale techniques have been widely shown to potentially overcome the limitation of homogenization schemes in representing the microscopic failure mechanisms in heterogeneous media as well as their influence on their structural response…
We present a comprehensive theoretical and computational model that explores the behavior of a thin hydrated film bonded to a non-hydrated / impermeable soft substrate in the context of surface and bulk elasticity coupled with surface…
The phase behavior of hydrocarbon fluids confined in porous media has been reported to deviate significantly from that in the bulk environment due to the existence of sub-10nm pores. Though experiments and simulations have measured the…
Hypothesis: Lateral accumulation and film defects during drying of hard particle coatings is a common problem, typically solved using polymeric additives and surface active ingredients, which require further processing of the dried film.…
The migration of liquids in porous media, such as sand, has been commonly considered at high saturation levels with liquid pathways at pore dimensions. In this letter we reveal a low saturation regime observed in our experiments with…
Anyone who has built a sandcastle recognizes that the addition of liquid to granular materials increases their stability. However, measurements of this increased stability often conflict with theory and with each other [1-7]. A…
We propose a heterogeneous reaction-diffusion model for the hydration and setting of cement. The model is based on diffusional ion transport and on cement specific chemical dissolution/precipitation reactions under spatial heterogeneous…
We investigate sedimentation of model hard sphere-like colloidal dispersions confined in horizontal capillaries using laser scanning confocal microscopy, dynamical density functional theory, and Brownian dynamics computer simulations. For…
The non-equilibrium dynamics of condensation phenomena in nano-pores is studied via Monte Carlo simulation of a lattice gas model. Hysteretic behavior of the particle density as a function of the density of a reservoir is obtained for…
The influence of miscibility and liquid wettability during droplet impact onto thin wall films is investigated experimentally. Despite similar liquid properties and impact conditions, differences in the splashing limit, the crown extension…
Transport phenomena in porous media are commonplace in our daily lives. Examples and applications include heat and moisture transport in soils, baking and drying of food stuffs, curing of cement, and evaporation of fuels in wild fires. Of…
Cement is one of the most produced materials in the world. A major player in greenhouse gas emissions, it is the main binding agent in concrete, to which it provides a cohesive strength that rapidly increases during setting. Understanding…
In this study, we investigate the appeared complexity of two-phase flow (air-water) in a heterogeneous soil where the supposed porous media is non-deformable media which is under the time-dependent gas pressure. After obtaining of governing…
Nanoscale topographic features of solid surfaces can induce complex metastable behavior in colloidal and multiphase systems. Recent studies on single microparticle adsorption at liquid interfaces have reported a crossover from fast…
In this paper, we experimentally quantify and analytically model rate dependent capillary heterogeneity trapping. Capillary heterogeneity trapping enhances non-wetting fluid trapping beyond pore-scale residual trapping through the isolation…
Stability of coarse particles against gravity is an important issue in dense suspensions (fresh concrete, foodstuff, etc.). On the one hand, it is known that they are stable at rest when the interstitial paste has a high enough yield…
Three-dimensional X-ray microtomography, coupled to rheometric measurements, enables a morphology-resolved reconstruction of capillary stresses at the grain scale in unsaturated wet granular materials. Liquid domains are automatically…
Starch-water slurries are commonly used to study fracture dynamics. Drying starch-cakes benefit from being simple, economical, and reproducible systems, and have been used to model desiccation fracture in soils, thin film fracture in paint,…
We develop a diffuse solid method that is versatile and accurate for modeling wetting and multiphase flows in highly complex geometries. In this scheme, we harness N + 1-component phase field models to investigate interface shapes and flow…
We study experimentally the impact on rigid surfaces of different soft porous solids saturated with liquid: hydrogel balls and liquid-saturated foam balls. The static con tact of such soft solids with the substrate is well described by…