Related papers: Doubling Phase Shifters for Efficient Hybrid Preco…

A dual-scale deployment (DSD) framework is proposed for pinching antenna systems (PASS), under which four protocols are provided. 1) For the coarse-scale deployment, the pinching antenna (PA) is transferred over a large-scale range at the…

Low-resolution analog-to-digital converters (ADCs) have emerged as an efficient solution for massive multiple-input multiple-output (MIMO) systems to reap high data rates with reasonable power consumption and hardware complexity. In this…

This paper studies the instantaneous rate maximization and the weighted sum delay minimization problems over a K-user multicast channel, where multiple antennas are available at the transmitter as well as at all the receivers. Motivated by…

At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…

Rate-splitting multiple access (RSMA) has been studied for multiuser multiple-input multiple-output (MUMIMO) systems especially in the presence of imperfect channel state information (CSI) at the transmitter. However, its precoding designs…

MIMO systems are considered as most promising for wireless communications. However, with an increasing number of radio front ends the corresponding energy consumption and costs become an issue, which can be relieved by the utilization of…

Aiming at maximizing the achievable sum-rate of wideband multiuser mmWave massive MIMO systems, the hybrid precoding is studied. Since each computation of the achievable sum-rate can be performed only after the analog precoder and digital…

This paper considers a wideband millimeter-wave MIMO system with fully digital transceivers at both the base station and the user equipment (UE), focusing on mobile scenarios. To reduce the baseband processing burden at the UE, we propose a…

This paper introduces a unified deep neural network (DNN)-based precoder for two-user multiple-input multiple-output (MIMO) networks with five objectives: data transmission, energy harvesting, simultaneous wireless information and power…

We consider a linear precoder design for an underlay cognitive radio multiple-input multiple-output broadcast channel, where the secondary system consisting of a secondary base-station (BS) and a group of secondary users (SUs) is allowed to…

Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems have been considered as one of the primary candidates for the fifth generation (5G) and beyond 5G wireless communication networks to satisfy the ever-increasing…

High-speed signal processing is essential for maximizing data throughput in emerging communication applications, like multiple-input multiple-output (MIMO) systems and radio-frequency (RF) interference cancellation. However, as these…

Relay-aided transmission is envisioned as a key strategy to combat severe path loss and link blockages emerging as unique challenges in millimeter-wave (mmWave) communications. This work considers a relay-aided multiuser mmWave…

The primary source of nonlinear distortion in wireless transmitters is the power amplifier (PA). Conventional digital predistortion (DPD) schemes use high-order polynomials to accurately approximate and compensate for the nonlinearity of…

Benefiting from the growth of the bandwidth, Terahertz (THz) communication can support the new application with explosive requirements of the ultra-high-speed rates for future 6G wireless systems. In order to compensate for the path loss of…

Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…

This paper considers a $K$-user multiple-input single-output (MISO) interference channels for simultaneous wireless information and power transfer (SWIPT), where each multi-antenna transmitter serves a single-antenna receiver per user pair.…

A two-stage hybrid transceiver is designed by considering a partially connected architecture at the base station (BS) for a low-resolution multi-user (MU) THz massive multiple input multiple output (MIMO) system. Due to its high bandwidth…

This work jointly addresses user scheduling and precoder/combiner design in the downlink of a wideband millimeter wave (mmWave) communications system. We consider Orthogonal Frequency Division Multiplexing (OFDM) modulation to overcome…

The evolution of 5G New Radio (NR) has brought significant improvements in signal strength and service quality for users. By integrating Multiple Input Multiple Output (MIMO) systems into communications, multiple data streams can be…