Related papers: One-bit LFMCW Radar: Spectrum Analysis and Target …
Although routinely utilized in literature, orthogonal waveforms may lose orthogonality in distributed multi-input multi-output (MIMO) radar with spatially separated transmit (TX) and receive (RX) antennas, as the waveforms may experience…
In this paper, we propose a practical receiver for multicarrier signals subjected to a strong memoryless nonlinearity. The receiver design is based on a generalized approximate message passing (GAMP) framework, and this allows real-time…
In this paper, we present a high resolution microwave imaging technique using a compact and low cost single channel Frequency Modulated Continuous Wave (FMCW) radar based on Circular Synthetic Aperture Radar (CSAR) technique. We develop an…
A prior-guided deep learning (DL) based interference mitigation approach is proposed for frequency modulated continuous wave (FMCW) radars. In this paper, the interference mitigation problem is tackled as a regression problem. Considering…
We propose a novel integrated sensing and communication (ISAC) system that leverages sensing to assist communication, ensuring fast initial access, seamless user tracking, and uninterrupted communication for millimeter wave (mmWave)…
In this paper we propose to bridge the gap between using extremely low resolution 1-bit measurements and estimating targets' parameters, such as their velocities, that exist in a continuum, i.e., by performing Off-the-Grid estimation. To…
We address the challenging problem of estimating the directions-of-arrival (DOAs) of multiple off-grid signals using a single snapshot of one-bit quantized measurements. Conventional DOA estimation methods face difficulties in tackling this…
Digital beamforming and waveform generation techniques in MIMO radar offer enormous advantages in terms of flexibility and performance compared to conventional radar systems based on analog implementations. To allow for such fully digital…
Millimeter-wave (mmWave) OFDM radar equipped with rainbow beamforming, enabled by phase-time arrays (PTAs), provides wide-angle coverage and is well-suited for fast real-time target detection and tracking. However, accurate detection of…
In this work, a microwave photonic prototype for concurrent radar detection and spectrum sensing is proposed, designed, built, and investigated. A direct digital synthesizer and an analog electronic circuit are integrated to generate an…
The use of low-resolution data converters in the radio-frequency (RF) chains of all-digital massive multiple-input multiple-output (MIMO) basestations promises significant reductions in power consumption, hardware costs, and interconnect…
Traffic safety is the foremost value that automotive radar systems aim to pursue. Unlike in mobile communication systems, the literature for radar systems did not adequately address inter-radar interference and security threats such as…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
Displaced automotive sensor imaging exploits joint processing of the data acquired from multiple radar units, each of which may have limited individual resources, to enhance the localization accuracy. Prior works either consider perfect…
This paper focuses on the combined radar and communications problem and conducts a thorough analytical investigation on the effect of phase and frequency change on the communication and sensing functionality. First, we consider the…
Synergistic design of communications and radar systems with common spectral and hardware resources is heralding a new era of efficiently utilizing a limited radio-frequency spectrum. Such a joint radar-communications (JRC) model has…
In this paper, we address the problem of target detection in the presence of coherent (or fully correlated) signals, which can be due to multipath propagation effects or electronic attacks by smart jammers. To this end, we formulate the…
Human Activity Recognition has gained significant attention due to its diverse applications, including ambient assisted living and remote sensing. Wearable sensor-based solutions often suffer from user discomfort and reliability issues,…
This paper presents a new detector for filtering noise from true detections in radar data, which improves the state of the art in radar odometry. Scanning Frequency-Modulated Continuous Wave (FMCW) radars can be useful for localization and…
Several current ultra-wide band applications, such as millimeter wave radar and communication systems, require high sampling rates and therefore expensive and energy-hungry analogto-digital converters (ADCs). In applications where cost and…