Related papers: RF Chain Reduction for MIMO Systems: A Hardware Pr…
This paper investigates the downlink of massive multiple-input multiple-output (MIMO) systems that include a single cell Base Station (BS) equipped with large number of antennas serving multiple users. As the number of RF chains is getting…
Radio-frequency (RF) impairments, that exist intimately in wireless communications systems, can severely degrade the performance of traditional multiple-input multiple-output (MIMO) systems. Although compensation schemes can cancel out part…
The performance of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems is limited by the sparse nature of propagation channels and the restricted number of radio frequency (RF) chains at transceivers. The introduction of…
Millimeter wave (mmWave) multi-user massive multi-input multi-output (MIMO) is a promising technique for the next generation communication systems. However, the hardware cost and power consumption grow significantly as the number of radio…
Hybrid analog and digital (HAD) beamforming has been recently receiving considerable deserved attention for a practical implementation on the large-scale antenna systems. As compared to full digital beamforming, partial-connected HAD…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
In millimeter wave communications, hybrid analog-digital arrays consisting of only a few radiofrequency (RF) chains offer an attractive alternative to costly digital arrays. A limitation to hybrid arrays is that the number of streams that…
In millimeter wave (mmWave) systems, antenna architecture limitations make it difficult to apply conventional fully digital precoding techniques but call for low cost analog radio-frequency (RF) and digital baseband hybrid precoding…
In this paper, we derive a closed-form expression for the combiner of a multiple-input-multiple-output (MIMO) receiver equipped with a minimum-mean-square-error (MMSE) estimator. We propose using variable-bit-resolution analog-to- digital…
This chapter focuses on a hardware architecture for semi-passive Reconfigurable Intelligent Surfaces (RISs) and investigates its consideration for boosting the performance of Multiple-Input Multiple-Output (MIMO) communication systems. The…
The highly sparse nature of propagation channels and the restricted use of radio frequency (RF) chains at transceivers limit the performance of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems. Introducing…
Massive MIMO can greatly increase both spectral and transmit-energy efficiency. This is achieved by allowing the number of antennas and RF chains to grow very large. However, the challenges include high system complexity and hardware energy…
Hybrid analog-digital architectures are considered as promising candidates for implementing millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems since they enable a considerable reduction of the required number of…
Hybrid beamforming (HBF) includes analog beamforming with phase shifted array in RF domain and digital beamforming in baseband domain. Phase shifted array is usually made up with a large amount of phase shifters. Limited to the…
Massive multi-user (MU) multiple-input multiple-output (MIMO) systems are one possible key technology for next generation wireless communication systems. Claims have been made that massive MU-MIMO will increase both the radiated energy…
This article introduces an energy and spectral efficient multiple-input multiple-output orthogonal frequency division multiplexing (MIMO-OFDM) transmission scheme designed for the future sixth generation (6G) wireless communication…
This paper proposes a correlation-based three-stage channel estimation strategy with low pilot overhead for reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) multi-user (MU) MIMO systems, in which both users and base…
In this paper, we study the hybrid precoding structures over limited feedback channels for massive multiuser multiple-input multiple-output (MIMO) systems. We focus on the system performance of hybrid precoding under a more realistic…
This paper investigates the hybrid precoding design for millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems with finite-alphabet inputs. The mmWave MIMO system employs partially-connected hybrid precoding architecture…
In this work, we address the problem of channel estimation and precoding / combining for the so-called hybrid millimeter wave (mmWave) MIMO architecture. Our proposed channel estimation scheme exploits channel reciprocity in TDD MIMO…