Related papers: Impact of 3D Antenna Radiation Patterns on TDOA-Ba…
This paper investigates unmanned aerial vehicle (UAV) localization using time difference of arrival (TDOA) measurements under mixed line-of-sight (LOS) and non-line-of-sight (NLOS) conditions. A 3D TDOA Cram\'er-Rao lower bound (CRLB) model…
Ensuring reliable and seamless wireless connectivity for unmanned aerial vehicles (UAVs) has emerged as a critical requirement for a wide range of applications. The increasing deployment of UAVs has increased the significance of…
Three dimensional (3D) radiation pattern of an antenna mounted at a drone can significantly influence the air-to-ground (A2G) link quality. Even when a drone transmitter is very close to a ground receiver, if the antenna orientations are…
Current trends in autonomous vehicles and their applications indicates an increasing need in positioning at low battery and compute cost. Lidars provide accurate localization at the cost of high compute and power consumption which could be…
This letter proposes an algebraic solution for the problem of 3-D source localization utilizing the minimum number of measurements, i.e., one Time Difference of Arrival (TDOA) and one Angle of Arrival (AOA) pair. The proposed method employs…
Providing seamless connectivity to unmanned aerial vehicle user equipments (UAV-UEs) is very challenging due to the encountered line-of-sight interference and reduced gains of down-tilted base station (BS) antennas. For instance, as the…
Angle of arrival (AOA) is widely used to locate a wireless signal emitter in unmanned aerial vehicle (UAV) localization. Compared with received signal strength (RSS) and time of arrival (TOA), it has higher accuracy and is not sensitive to…
This work performs the design, real-time hardware realization, and experimental evaluation of a positioning system by ultra-violet (UV) communication under photon-level signal detection. The positioning is based on time-difference of…
The use of drone base stations to provide wireless connectivity for ground terminals is becoming a promising part of future technologies. The design of such aerial networks is however different compared to cellular 2D networks, as antennas…
In this paper, considering an interference limited inband downlink cellular network, we study the effects of scheduling criteria, mobility constraints, path loss models, backhaul constraints, and 3D antenna radiation pattern on trajectory…
Current studies on Unmanned Aerial Vehicle (UAV) based cellular deployment consider UAVs as aerial base stations for air-to-ground communication. However, they analyze UAV coverage radius and altitude interplay while omitting or…
This paper explores the effects of three-dimensional (3D) antenna radiation pattern and backhaul constraint on optimal 3D path planning problem of an unmanned aerial vehicle (UAV), in interference prevalent downlink cellular networks. We…
Accurate indoor localization is a crucial enabling technology for many robotics applications, from warehouse management to monitoring tasks. Ultra-wideband (UWB) time difference of arrival (TDOA)-based localization is a promising…
We study the performance bounds of vehicle-to-vehicle (V2V) relative positioning for vehicles with multiple antenna arrays. The Cram\'{e}r-Rao bound for the estimation of the relative position and the orientation of the Tx vehicle is…
The use of amateur drones (ADrs) is expected to significantly increase over the upcoming years. However, regulations do not allow such drones to fly over all areas, in addition to typical altitude limitations. As a result, there is an…
The following paper presents an adaptive anchor pairs selection method for ultra-wideband (UWB) Time Difference of Arrival (TDOA) based positioning systems. The method divides the area covered by the system into several zones and assigns…
To provide a reliable wireless uplink for users in a given ground area, one can deploy Unmanned Aerial Vehicles (UAVs) as base stations (BSs). In another application, one can use UAVs to collect data from sensors on the ground. For a…
Localizing ground devices (GDs) is an important requirement for a wide variety of applications, such as infrastructure monitoring, precision agriculture, search and rescue operations, to name a few. To this end, unmanned aerial vehicles…
This article presents a radio frequency system that can be used to perform precise vertical landings of drones. The system is based on the three-way phase shift detection of a signal transmitted from the landing point. The antenna system is…
Over the last few years, the many uses of Unmanned Aerial Vehicles (UAVs) have captured the interest of both the scientific and the industrial communities. A typical scenario consists in the use of UAVs for surveillance or target-search…