Related papers: Low Resolution Digital-to-Analog Converter with Di…
This paper investigates the design of analog beamforming at the receiver in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, aided by full digital chains featuring 1-bit ADCs. We advocate utilizing these full digital…
This paper addresses the challenge of integrating multistatic coherent imaging functionalities in the downlink (DL) of a phase-coherent distributed multiple input multiple output (D-MIMO) communication network. During DL, the D-MIMO access…
We present a novel iterative detection and decoding scheme for the uplink of large-scale multiuser multiple-antenna systems. In order to reduce the receiver's energy consumption and computational complexity, 1-bit analog-to-digital…
High hardware cost and high power consumption of massive multiple-input and multiple output (MIMO) are two challenges for the future wireless communications including beyond fifth generation (B5G) and sixth generation (6G). Adopting the…
In massive multiple-input multiple-output (MIMO) downlink systems, the physical implementation of the base stations (BSs) requires the use of cheap and power-efficient power amplifiers (PAs) to avoid high hardware cost and high power…
We consider a MIMO fading broadcast channel and compute achievable ergodic rates when channel state information is acquired at the receivers via downlink training and it is provided to the transmitter by channel state feedback. Unquantized…
A Kramers-Kronig receiver with a continuous wave tone added digitally at the transmitter is combined with a digital resolution enhancer to limit the increase in transmitter quantization noise. Performance increase is demonstrated, as well…
High resolution digital micro-mirror devices (DMD) make it possible to produce nearly arbitrary light fields with high accuracy, reproducibility and low optical aberrations. However, using these devices to trap and manipulate ultracold…
Multiple-input multiple-output (MIMO) systems exploit spatial diversity to facilitate multi-user communications with high spectral efficiency by beamforming. As MIMO systems utilize multiple antennas and radio frequency (RF) chains, they…
The uplink performance of massive multiple-input-multiple-output (MIMO) systems where the base stations (BS) employ low-resolution analog-to-digital converters (ADCs) is analyzed. A high performance MMSE receiver that takes both additive…
Modern radio systems and transceivers utilize carrier aggregation (CA) to meet the demands for higher and higher data rates. However, the adoption of CA in the existing Long Term Evolution (LTE)-Advanced and emerging 5G New Radio (NR)…
Quantum error correction is one of the most important milestones for realization of large-scale quantum computation. To achieve this, it is essential not only to integrate a large number of qubits with high fidelity, but also to build a…
This paper proposes a deep learning approach to channel sensing and downlink hybrid beamforming for massive multiple-input multiple-output systems operating in the time division duplex mode and employing either single-carrier or…
A radio frequency (RF) power amplifier (PA) plays an important role to amplify the message signal at higher power to transmit it to a distant receiver. Due to a typical nonlinear behavior of the PA at high power transmission, a digital…
We propose and demonstrate a power-fading-aware noise-shaping technique for C-band IMDD system with low resolution DAC, which shapes and concentrates quantization noise within the fading-induced notch areas, yielding 94% improvement in…
- This paper describes a pipeline analog-to-digital converter is implemented for high speed camera. In the pipeline ADC design, prime factor is designing operational amplifier with high gain so ADC have been high speed. The other advantage…
In this work we extend the concept of uplink-downlink rate balancing to frequency division duplex (FDD) massive MIMO systems. We consider a base station with large number antennas serving many single antenna users. We first show that any…
In this paper, we propose a hybrid analog-digital beamforming architecture with resolution-adaptive ADCs for millimeter wave (mmWave) receivers with large antenna arrays. We adopt array response vectors for the analog combiners and derive…
Multiple-input multiple-output (MIMO) radar has waveform diversity and large spatial degrees of freedom (DoFs), making it attractive for high-resolution sensing. Scaling MIMO radar to massive arrays can further improve sensing performance,…
We investigate hybrid beamforming design for covert millimeter wave multiple-input multiple-output systems with finite-resolution digital-to-analog converters (DACs), which impose practical hardware constraints not yet considered by the…