Related papers: Multi-stage Antenna Selection for Adaptive Beamfor…
Spectrum congestion and competition over frequency bandwidth could be alleviated by deploying dual-function radar-communications systems, where the radar platform presents itself as a system of opportunity to secondary communication…
Millimeter Wave (mmWave) band provides a large spectrum to meet the high-demand capacity by the 5th generation (5G) wireless networks. However, to fully exploit the available spectrum, obstacles such as high path loss, channel sparsity, and…
A low cost solution for constructing receiver signal points is investigated that combines a large number of constrained radio frequency (RF) frontends with a limited number of full RF chains. The constrained RF front ends have low cost and…
Recently, a technique called beam-space MIMO has been demonstrated as an effective approach for transmitting multiple signals while using a single RF-chain. In this work, we present novel design considerations and a compact antenna solution…
Millimeter wave (mmWave) band, or high frequencies such as THz, has large undeveloped band of spectrum. However, wireless channels over the mmWave band usually have one or two paths only due to the severe attenuation. The channel property…
Theoretically, the three-dimensional (3D) array architecture provides a higher communication degree of freedom (DoF) compared to the planar arrays, allowing for greater capacity potential in multiple-input multiple-output (MIMO) systems.…
Cognitive multiple-input multiple-output (MIMO) radar is capable of adjusting system parameters adaptively by sensing and learning in complex dynamic environment. Beamforming performance of MIMO radar is guided by both beamforming weight…
Large multiple-input multiple-output (MIMO) networks promise high energy efficiency, i.e., much less power is required to achieve the same capacity compared to the conventional MIMO networks if perfect channel state information (CSI) is…
Hybrid beamforming via large antenna arrays has shown a great potential for increasing data rate in cellular networks by delivering multiple data streams simultaneously. In this paper, several beamforming design algorithms are proposed…
Beamspace multi-input multi-output (MIMO) relying on lens antenna arrays can significantly reduce the number of radio-frequency chains in millimeter-wave (mmWave) communication systems through beam selection. However, the beamforming gain…
The key obstacle to achieving the full potential of the millimeter wave (mmWave) band has been the poor propagation characteristics of wireless signals in this band. One approach to overcome this issue is to use antennas that can support…
Distributed phased arrays based multiple-input multiple-output (DPA-MIMO) is a newly introduced architecture that enables both spatial multiplexing and beamforming while facilitating highly reconfigurable hardware implementation in…
Practical hardware limitations often impose a reduced number of available phase shifts at the elements of a reconfigurable intelligent surface (RIS). Most works often assume continuous phase-shits at the RIS elements for the transmit and…
Distributed phased Multiple-Input Multiple-Output (phased-MIMO) radar systems have attracted wide attention in target detection and tracking. However, the phase-shifting circuits in phased subarrays contribute to high power consumption and…
In this paper, we propose a two-stage analog combining architecture for millimeter wave (mmWave) communications with hybrid analog/digital beamforming and low-resolution analog-to-digital converters (ADCs). We first derive a two-stage…
Multiple input multiple output (MIMO) system transmission is a popular diversity technique to improve the reliability of a communication system where transmitter, communication channel and receiver are the important elements. Data…
We investigate the capacity attainable for a multiuser MIMO uplink as we scale both array size and bandwidth for regimes in which all-digital arrays incur excessive hardware complexity and power consumption. We consider a tiled hybrid…
In this paper, the multiple-input multiple-output (MIMO) transmit beampattern matching problem is considered. The problem is formulated to approximate a desired transmit beampattern (i.e., an energy distribution in space and frequency) and…
The large spectrum available in the millimeter-Wave (mmWave) band has emerged as a promising solution for meeting the huge capacity requirements of the 5th generation (5G) wireless networks. However, to fully harness the potential of mmWave…
Recently, the remarkable potential of a multiple-input multiple-output (MIMO) wireless communication system was unveiled for its ability to provide spatial diversity or multiplexing gains. For MIMO diversity schemes, it is already known…